Mode Switching Summary
TEST 
Move
| AUTO |
|
|
|
| Flip light switch | ||
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| off for one second |
|
|
|
|
|
|
|
| then back on* |
MANUAL MODE |
|
| ||||||
|
|
| ||||||
|
| |||||||
*If you get confused while switching modes, turn the power off for one minute, then back on. After the cali- bration time the control will be in the AUTO mode.
INSTALLATION
For easy installation, select an existing light operated by a wall switch for replacement.
For best performance, mount the fixture about 8 feet (2.4 m) above the ground. NOTE: If fixture is mounted higher than 8 ft.(2.4 m), aiming the sensor down will reduce coverage distance.
CAUTION: The sensor must be mounted below the lamp housing for wall installations.
Eave Mount
Wall Mount
CAUTION to avoid fire or burn hazards:
•Allow fixture to cool before touching. The bulb and fixture operate at high temperatures.
•Keep fixture at least 2" (5 cm) from combustible materials. Do not aim at objects closer than 3 feet (1 m).
•
For under eave installation, the sensor head must be rotated as shown in the next two steps for proper operation and to avoid the risk of electrical shock.
For eave mount only:
❒Rotate the sensor head towards the clamp screw joint.
Control Switch
Joint Clamp 
❒Then rotate the sensor head clockwise 180° so the controls face down.