Carriage Light with Motion-activated Sensor
Model
Installation and
Operating Instructions
Features
•Automatically comes on when motion is de- tected.
•Automatically turns light off.
•Photocell keeps the light off during daylight hours.
This package includes:
• Mounting screws and wire connectors
Coach Light
Tail Assembly
Requirements
•The Light Control requires 120 volts AC.
•If you want to use Manual Mode, the control must be wired through a switch.
•Some electrical codes require installation by a qualified electrician. Please check the codes in your area.
Before installation, record the model num- ber listed inside the fixture. Attach receipt in case of possible warranty issues.
Model Number:
INSTALLATION
WARNING: Turn power off at circuit breaker or fuse.
For best performance, mount the fixture about 6 feet (1.8 m) above the ground.
1.Remove two decorative nuts.
2.Remove mounting plate.
3.Tighten mounting screws finger tight.
4.Attach mounting plate to junction box.
Decorative Nut
Mounting
Plate
Mounting Screw
Wire Path | Ground Screw | |
| ||
| Junction | |
Bracket | Box | |
| ||
Mounting | Mounting | |
Screw | ||
Plate | ||
|
Note: We recommend having an assistant help hold the lantern assembly during the wiring process.
Horizontal Junction Boxes Only:
Fixture |
| Ground |
| Screw | |
Screw | Wire |
|
|
| |
| Path | Fixture |
|
| |
| Junction Box | Screw |
|
| |
| Screws |
|
Remove ground screw and 2 fixture screws from the mounting plate. Flip plate over. Reinsert ground screw. Insert the 2 fixture screws in the holes near the junction box screws holes. Wire path must be located as shown above.