Fedders A6V05S2B Before you start, Sliding Window Installation, Tools Needed, Window Requirements

INSTALLATION

WINDOW INSTALLATON

Before you start:

Window Requirements:

Your new room air conditioner is factory prepared for easy installation in a horizontal sliding or casement type window with a minimum width of 15 1/2 inches. Unit will fit a 42 inch high window opening as received from factory.

Tools Needed

Screwdrivers

Knife

DInstallation Parts Kit

Fastener Identification

A	B	C	Description	Quantity
		A	1” long wood screws	2
		B	3/8” Self tapping screws	7
		C	7/16” mach. screws/nuts	2
		D	Leveling Bolt/ Nut	1
	E	E	Speed Clips	2

Tape Measure

Drill

Carpenter’s Level

The installation is intended to be permanent, and when installed in apartment or rental properties, permission to make modifications should be obtained from owners or landlords of buildings prior to installation of unit.

Sliding Window Installation

1.Choose the installation site. It is imperative that window frame assembly and side of structure are adequate to support weight of unit. Reinforce if necessary.

2.Slide open one window sash to install support platform.

3.Attach support platform to sill plate with three (3) 3/8” long self- tapping screws (Fig. 3).

4.Loosely attach support angle to bottom of support platform using two (2) 7/16” long machine screws, flat washers, and nuts.

5.Place support platform against lower window track and firmly against vertical edge of window frame (Fig. 4).

6.Attach support platform to window sill using two (2) 1” long self-tapping screws (Fig. 4).

If required, overcome interference of support platform with window track or storm windows by securely attaching a shim strip to the window sill. Strip should be as long as width of support platform and flush with back edge of sill. Thickness of strip should be controlled by amount of interference.

7.Pull support angle against outside of structure. Tighten two (2) 7/16” long machine screws on top of support platform (Fig. 3).

8.Adjust leveling bolt to position support angle in a level plane. This will allow for proper angle. Tighten leveling bolt locknut (Fig. 3).

Important: Unit must be level or tilted back slightly to facilitate proper condensate disposal.

Make sure unit is unplugged before removing the decorative front.

It is recommended that you have help to install your unit and that you use proper lifting technique to avoid personal injury.

Make sure unit is unplugged before removing chassis from cabinet.

Use caution when working around exposed sharp edges of the cabinet and sharp coils to avoid injury or torn clothing.

Fig. 3		SUPPORT PLATFORM ASSEMBLY
			B	C
		A
				D
		E
				F
A	Support Platform			E Support Angle
B	7/16” mach. screws			F Leveling Bolt
C 3/8” Self tapping screws
D Sill plate
Fig. 4				A
			A
		B
				D
		C
			E

A	1” long screws	D	Window Sill
B	Support Platform	E	Shim Strip

CLower window track

3