Solid State Logic 82S6XL010D Mains Supply and Phases, Mains Isolation and Over-Current Protection

Page 9

Safety Considerations

Mains Supply and Phases

Solid State Logic equipment is designed for connection to single phase supplies with the Neutral conductor at earth potential – category TN – and is fitted with a protective fuse in the Live conductor only. It is not designed for use with Phase (Live) and Neutral connections reversed or where the Neutral conductor is not at earth potential (TT or IT supplies).

Mains cables will be coded with the following colour scheme:

LIVE:Brown

NEUTRAL: Blue

EARTH: Yellow/Green

Mains Isolation and Over-Current Protection

An external disconnect device is required for this equipment which must be installed according to current wiring regulations. A detachable power cord, as fitted to this equipment, is a suitable disconnect device.

An external over-current protection device is required to protect the wiring to this equipment which must be installed according to the current wiring regulations. The fusing or breaking-current are defined in the product specification. In certain countries this function is supplied by use of a fused plug.

CE Certification

Note that the majority of cables supplied with SSL equipment are fitted with ferrite rings at each end. This is to comply with current European CE regulations and these ferrites should not be removed.

If any of the unit metalwork is modified in any way this may the adversely affect the CE certification status of the product.

FCC Certification

The XLogic unit has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Page 5

Image 9
Contents Multichannel Compressor Page Solid State Logic Solid State Logic Contents XLogic Multichannel Compressor rear XLogic Multichannel Compressor frontWarranty Repairs WarrantyOut of Warranty Repairs IntroductionElectrical Safety Warning Safety considerationsInstallation DefinitionsMains Isolation and Over-Current Protection Mains Supply and PhasesCE Certification FCC CertificationVoltage Selection InstallationMounting ConnectionSide Chain Adjust Section OperationCompressor Controls Fader Section Mode SectionAppendix a Internal links and fuses Appendix B Connector DetailsAppendix C Performance Specification Appendix D Calibration Information Side Chain Gain AdjustmentDC Calibration Side Chain Trim CalibrationInput Measure Adjust VCA Gain AdjustInput Adjust Distortion NullAppendix F Environmental Specification Appendix E Physical specification