Beko WME 7267 S, WME 7267 W Ending the programme through cancelling, Programme in rinse hold mode

To deactivate the child-proof lock, press the 2nd and 4th auxiliary function buttons for 3 sec.

“C:OFF” (Child lock is deactivated) label

appears on the screen.

Ending the programme through cancelling

“Start/Pause/Cancel” button (Figure

1-8) is pressed for 3 seconds to cancel the programme. Start symbol (Figure 2-2j) will flash during cancellation. After cancellation, the symbol of the corresponding step at which the cancellation was made will remain lit and

“End” label will appear on the screen.

Programme in rinse hold mode

•This process is shown with the flashing Spin Symbol (Figure 2-2c) and the lit up Standby Symbol

(Figure 2-2k).

If you wish to spin when the machine is in this mode:

Adjust the spin speed. Press “Start/ Pause/Cancel” button (Figure 1-8). The programme continues, pumps out the water and spins. Standby Symbol (Figure 2-2k) fades out and Start Symbol (Figure 2-2j) lights up.

If you want to discharge the water only without spinning:

Press “Start/Pause/Cancel” button

(Figure 1-8). Standby symbol (Figure

2-2k) will fade. Start symbol (Figure 2-2j) will light up. The programme continues and only pumps out the water.

End of programme

When the programme is finished, the symbols of the relevant steps will remain lit up and the auxiliary function, spin and temperature data selected at the start-up of the programme will remain selected. “End” label will appear on the screen.

23

EN