Beko WME 7267 W, WME 7267 S manual General Safety, First Use, Intended use, Safety instructions

Page 6

2Warnings

Please read the following information. Otherwise, there may be the risk of personal injury or material damage. Moreover, any warranty and reliability commitment will become void.

may be caused by the software. Press “Start/Pause/Cancel” button for 3 seconds to cancel the program set in your machine before calling the authorized service.

General Safety

Never place your machine on a carpet covered floor. Otherwise, lack of airflow from below your machine may cause electrical parts to overheat. This may cause problems with your washing machine.

If the power cable or mains plug is damaged you must call Authorized Service for repair.

Check water hoses for wear. Do not use old/used water inlet hoses. These may cause stains on your laundry.

Fit the drain hose into the waste water system securely to prevent any water leakage and to allow machine to take in and discharge water as required. It is very important that the water intake and drain hoses are not folded, squeezed, or broken when the appliance is pushed into place after it is installed or cleaned.

Your washing machine is designed to continue operating when the power restores after a power interruption. You cannot cancel any program by pressing the “On/Off button.” The machine will resume its program when the power restores.

Press the “Start/Pause/Cancel” button for 3 seconds to cancel the program (See, Cancelling a Program)

There may be some water in your machine when you receive it. This is from the quality control process and is normal. It is not harmful to your machine.

Some problems you may encounter

First Use

To prepare your machine for washing, carry out your first washing process without loading your machine and with detergent under “Cottons 90°C” program.

Ensure that the cold water connections has been made correctly when installing your machine.

If the current fuse or circuit breaker is less than 15 Amperes, please have a qualified electrician install a 15 Ampere fuse or circuit breaker.

To make your machine ready for use, please be sure that the tap water supply and water drainage systems are appropriate before calling the authorized service. If they are not, call a qualified plumber to have any necessary arrangements carried out.

Intended use

This product has been designed for home use.

The appliance may only be used for washing and rinsing of textiles that are marked accordingly.

Only detergents, softeners and supplements suitable for washing machines may be used.

Observe the care instructions labelled on textile products and any other instructions given by companies that produce detergents for your machine.

Safety instructions

This appliance must be connected to an earthed outlet protected by a fuse of suitable capacity.

6

EN

Image 6
Contents Automatic washing machine WME 7267 W WME 7267 S Explanation of symbols Please read this manual firstTable of Contents Your Washing Machine OverviewSpecifications First Use General SafetySafety instructions Intended useIf there are children in your House Electrical connectionElectrical requirements Fitting a different plug Adjusting the feet InstallationAppropriate installation location Removing packaging reinforcementConnecting to the water supply Connecting to the drainDestroying the packaging material Disposing of the old machinePreparing clothes for washing Initial preparations for washingSorting the laundry Correct load capacityDetergents and softeners Detergent, softener and other cleaning agentsLoading door Detergent drawerStarch SoftenerLiquid detergent Eliminating lime formationSelecting a programme and operating your machine Control panelDisplay symbols Turning the machine onProgramme selection Additional programmes Special programsTemperature selection Spin Speed selectionProgramme selection and consumption table Auxiliary functions Time screenStarting the programme Changing the delay timeCancelling the time delay Progress of programmeChild/key lock Switching the machine to standby modeChanging the selections after the programme has started SpinEnding the programme through cancelling Programme in rinse hold modeEnd of programme Quick instructions for daily use Page Outer cabinet and control panel Cleaning and careDetergent drawer Inlet water filtersDraining any remaining water and cleaning the pump filter Page Solution suggestions for problems Cause Explanation / SuggestionRun either the Pump or Spin program Detergent can stick to the laundry Oily accumulations on the drum may Detergent in the main wash Page Guarantee UK Mainland & Northern Ireland ServiceService once the manufacturers guarantee has expired Republic of IrelandPage Page