ACCESSORIES |
|
The following recommended accessories are currently available at retail stores: |
|
n Biscuits 100 pieces | Size 0 |
n Biscuits 100 pieces | Size 10 |
n Biscuits 100 pieces | Size 20 |
n Biscuit Assortment | 400 pieces total |
Size 0 | 100 pieces |
Size 10 | 100 pieces |
Size 20 | 200 pieces |
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury.
TROUBLESHOOTING
PROBLEM | SOLUTION |
|
|
1.Biscuits do not fit the slots. Biscuits not fitting slots may also cause misalign- ment of the boards being joined.
A.Biscuit slots are too deep or too shallow. Make fine adjustments to depth setting. See “MAKING FINE ADJUSTMENTS”.
B.Biscuit thickness may be out of tolerance. Compress biscuits in a vise if they are too thick.
C.Check to see if biscuits are the correct size for the size slots that have been cut: #0, #10, or #20.
D.Check to see if biscuits have gotten wet and have swelled.
2.Wood particles begin to back up on the front of the unit.
A. The dust collection system is not functioning properly. The dust bag may be full. Empty the dust bag often. See “INSTALLING/REMOVING DUST BAG”.
B. The dust port may be clogged, preventing wood particles from being drawn into the dust bag. Remove the front and rear base assemblies and clean blade, bearing plate, base assembly slots, and surrounding areas. See “CLEANING THE BASE ASSEMBLY AND DUST PATH”.
3.Blade becomes difficult to push in when cutting slots. Blade does not retract properly when cutting slots.
A.Wood particles and resin have built up on base assembly slots and sur- rounding areas. Remove front and rear base assemblies and clean blade, bearing plate, base assembly slots and surrounding areas. Apply a thin coat of general purpose grease in slots or on bearing plate where base slides. See “CLEANING THE BASE ASSEMBLY AND DUST PATH”.
4.Cutting performance is poor and there is a loss of power or stalling of motor when cutting slots.
A.Blade is dull. Replace the blade. See “REPLACING THE BLADE”.
B.Resin has built up on the blade. Remove the blade and clean blade with gum and pitch remover. See “REPLACING THE BLADE”.
24