ENGLISH | (Original instructions) |
Warning! The vibration emission value during actual use of the power tool can differ from the declared value depending on the ways in which the tool is used. The vibration level may increase above the level stated.
When assessing vibration exposure to determine safety measures required by 2002/44/EC to protect persons regularly using power tools in employment, an estimation of vibration exposure should consider, the actual conditions of use and the way the tool is used, including taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time.
Labels on tool
:The following pictograms are shown on the tool:
#This tool is double insulated; therefore no earth wire is required. Always check that the power supply corresponds to the voltage on the rating plate.Electrical safety
uIf the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1.On/off switch
2.
3.Shavings discharge outlet
4.Shavings discharge outlet selector
5.Planing depth adjustment knob
6.Planing depth graduation
Assembly
Warning! Before assembly, make sure that the tool is switched off and unplugged.
Replacing the cutting blades (fig. A)
The cutting blades provided with this tool are reversible. Replacement cutting blades can be obtained from your local retailer.
Removing
uLoosen the bolts (7) using the spanner supplied.
uSlide the blade (8) out of the holder.
uReverse the blade so that the unused side comes in posi- tion. If both sides are worn, the blade must be replaced.
Fitting
uSlide the blade into the holder until it is against the end stop.
uTighten the bolts using the spanner supplied. Warning! Always replace both cutters.
Adjusting the depth of cut (fig. B)
The depth of cut is indicated by the marking (9). The setting range can be read from the graduation (6).
uTurn the planing depth adjustment knob (5) to the required depth of cut.
uTurn the knob to the ‘P' postion whenever the tool is not in use.
Fitting and removing the parallel fence (fig. C)
The parallel fence is used to for optimum control on narrow workpieces.
uThread the knob (11) into the hole on the side of the planer and securely tighten.
uLoosen the parallel fence adjustment knob (10).
uSlide the parallel fence into the desired position.
uSecurely tighten the parallel fence adjustment knob.
Note : The parallel fence should be below the planer when installed correctly.
uTo remove the parallel fence proceed in reverse order.
Connecting a vacuum cleaner to the tool (fig. D)
An adaptor is required to connect a vacuum cleaner or dust extractor to the tool. The adaptor can be purchased from your local Black & Decker retailer.
uSlide the adaptor (12) over the shavings discharge outlet
(3).
uConnect the vacuum cleaner hose (13) to the adaptor.
Fitting the shavings collection bag (fig. E)
The shavings collection bag is particularly useful when working in confined spaces.
uSlide the connecting plate (14) of the bag over either side of the shavings discharge outlet (3).
uTo prevent chips from coming out opposite side of shav- ings discharge outlet, move the shavings discharge outlet selector (4) to the opposite side from the bag.
Emptying the shavings collection bag
The shavings collection bag should be emptied regularly while using it to prevent blocking.
uUnzip the bag and empty it before continuing.
6