Global Machinery Company BJ110M instruction manual Turning on and off

3.	Whilst holding the spindle lock
		K
	button rotate the blade by
	hand until the blade locks in
	place (fig K).
4.	Whilst depressing the spindle
	lock button, turn the blade
	flange anti-clockwise using the
	pin wrench provided (fig L).
5.	Remove the outer blade
		L
	flange (fig M).
6.	Remove the blade from the
	inner flange.
7.	Clean the blade flanges
	thoroughly before mounting
	the new blade. Wipe a drop
	of oil onto the inner and outer
	flange where they will touch
		M
	the blade.

8.Mount the new blade onto the spindle and against the inner flange.

9.Replace the outer flange and tighten.

WARNING. The direction in which the blade rotates has to be the same as the direction of

the arrow marked on the housing.

10. Ensure that the spindle lock button is released.

IMPORTANT. After replacing the saw blade, make sure that the saw blade runs freely by turning the blade by hand.

11.Replace the base plate and secure with the 4 screws.

12.Plug the machine into a power socket and run the biscuit joiner under no load to check that it runs smoothly before using it to cut any material.

Turning on and off

1.Connect the plug to the power point.

2.Start the tool by squeezing the on/off trigger switch (fig N).

3.Release the trigger to stop the tool.

4.If you press the lock-on button while the trigger switch is depressed, the switch is kept in the operating position (fig O).

N O

5.The lock-on button allows the operator to keep the biscuit joiner motor running without continuously holding the switch. It is useful when operating the tool for extended periods.

6.To release the lock-on button, press and release the trigger switch

10