3.Cut the slots into the workpiece that will become the vertical board.
4.Cut the slots into the workpiece that will become the horizontal board
5.Once all the slots are cut insert a biscuit into each joint and dry assemble the workpieces to ensure everything lines up and fits.
6.Insert a
7.Place the biscuits in position and clamp the joint until the biscuits swell and the glue sets.
Maintenance
All the bearings are sealed ball bearings, lubricated for life, and require no maintenance.
Regularly check that all the fixing screws are tight. They may vibrate loose over time.
Power cord maintenance
If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an authorised service centre in order to avoid a safety hazard.
Cleaning
1.Keep the tool’s air vents unclogged and clean at all times.
2.Remove dust and dirt regularly. Cleaning is best done with a rag. Wear safety goggles or an eye shield and gloves whist cleaning.
3.
4.Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a damp cloth is recommended. Water must never come into contact with the tool.
13