c. Disconnect the plug from the power source before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc., in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
Additional safety rules for biscuit joiners
•Hold tool by insulated gripping surfaces when performing an operation where the cutting tools may contact hidden wiring or its own cord. Contact with a “live” wire will make exposed metal parts of the tool “live” and shock the operator.
•Fully unwind cable drum extensions to avoid potential overheating.
•When an extension cable is required, you must ensure that it has the right ampere rating for your power tool and is in safe electrical condition.
•Ensure your mains supply voltage is the same as your tool rating plate voltage.
•If possible, always use clamps or a vice to hold your work.
•Always switch off before you put the biscuit joiner down.
•Ensure that the lighting is adequate.
•Keep the area free of tripping hazards.
•Do not let anyone under 18 years operate this tool.
•Only use accessory blades that are in good condition.
•Do not touch the blade after operation. It will be hot.
•Keep yours hands away from under the workpiece.
•Never use your hands to remove chips or waste close by the blade.
•Rags, cloths, cord, string and the like should never be left around the work area.
•Support the work properly.
•Periodically check that all nuts, bolts and other fixings are properly tightened.
•When using the tool, use safety equipment including safety glasses or shield, ear protection, and protective clothing including safety gloves. Wear a dust mask if the operation creates dust.
•If in doubt, do not plug in the tool.
•Using a power source with a voltage less than the nameplate rating is harmful to the motor.
Wear goggles
Wear earmuffs
Wear a breathing mask
The tool must be used only for its prescribed purpose. Any use other than those mentioned in this Manual will be considered a case of misuse. The user and not the manufacturer shall be liable for any damage or injury resulting from such cases of misuse.
5