Jet Tools JJ-8CS owner manual Installing V-Belts, Installing Cutterhead Guard

Page 12

Installing V-Belts

1.Disconnect the machine from the power source, unplug.

2.Remove the lock knob (A, Fig. 14) and belt guard (B, Fig. 14).

3.Place v-belts onto cutterhead pulley grooves and through opening in stand.

4.Pull v-belts down and place onto motor pulley (Fig. 15). If necessary, loosen the mounting screws (A, Fig. 15) and slightly lift motor. Re- tighten the screws when belt is placed.

5.Check to make sure that motor pulley and cutterhead pulley are vertically aligned and the v-belt does not contact the sides of the opening in the base. If the pulleys are not aligned, loosen the screws (A, Fig. 15) on the motor base and slide the motor until the belt is aligned. Re- tighten screws.

6.The v-belt is properly tensioned when finger pres- sure on the belt half way between the two pul- leys causes 1/2" deflection. If the belt is too loose, loosen the lower screws (B, Fig. 15) on the mounting plate and push down on the plate. When belt tension is correct, re-tighten screws.

7.After two hours of operation, check belt tension again. Re-tension if necessary.

8.Re-install belt guard and lock knob.

Installing Cutterhead Guard

1.Orient guard (Fig. 16) in proper position and insert post into hole in table. Tighten lock screw (A, Fig. 16).

Fig. 14

Fig. 15

Fig. 16

12

Image 12
Contents JJ-8CS Woodworking Jointer Warranty & Service Volts Total Length of Cord in Feet AWGPage Table of Contents IntroductionSpecifications Levers and ControlsContents of Shipping Cartons Tools Required for AssemblyUnpacking and Cleanup Installing Bed to Stand Installing HandwheelsAssembling Knife-Setting Gauge Fence AdjustmentLeveling Outfeed Table with Cutterhead Knives Illustrates the outfeed table at the correct height Installing V-Belts Installing Cutterhead GuardDisconnect the machine from the power source, unplug Installing Access Cover Installing Dust ChuteIf the access door latch needs adjustment Electrical ConnectionsOperation Jointing Warped Material Direction of GrainBevel Cut Taper CutRabbet Cut Removing and Replacing KnivesGib Adjustment LubricationBlade Care Sharpening the Knives Cutterhead RemovalTrouble Possible Cause Solution Trouble-shootingFence Assembly Parts List for the JJ-8CS Woodworking Jointer Fence Assembly Index Part Description Size QtyBed Assembly 16 x 1-1/4 Stand and Motor Assembly JC-M01W Cutterhead Assembly Cutterhead Assembly Wiring Diagram