Jet Tools JJ-8CS owner manual Installing Bed to Stand, Installing Handwheels

Page 8

Installing Bed to Stand

1.Use an assistant or hoist mechanism to place bed assembly on top of stand. Be sure identi- fication label on the bed faces the same direc- tion as the label on the stand (Fig. 1).

2.Line up two holes in top of stand with holes in bed assembly by viewing through access door in stand.

3.Attach bed assembly to stand with two 3/8" lock bolts and lock washers (Fig. 2). Hand tighten only at this time.

4.Line up third hole in stand with hole in bed as- sembly by viewing through dust chute.

5.Install third 3/8" lock bolt and lock washer through dust chute to secure bed to stand.

6.Tighten all three mounting bolts with 14mm wrench.

Installing Handwheels

1.Remove protective tape from shaft, and remove screw and washer.

2.Press handwheel (A, Fig. 3) onto shaft, align- ing the key way with the key. If necessary, use a hammer with a block of wood to tap the handwheel completely onto the shaft.

3.Re-install screw and washer (B, Fig. 3).

4.Mount handle (C, Fig. 3) onto handwheel.

Fig. 1

Fig. 2

Fig. 3

8

Image 8
Contents JJ-8CS Woodworking Jointer Warranty & Service Volts Total Length of Cord in Feet AWGPage Table of Contents IntroductionSpecifications Levers and ControlsUnpacking and Cleanup Contents of Shipping CartonsTools Required for Assembly Installing Bed to Stand Installing HandwheelsAssembling Knife-Setting Gauge Fence AdjustmentLeveling Outfeed Table with Cutterhead Knives Illustrates the outfeed table at the correct height Disconnect the machine from the power source, unplug Installing V-BeltsInstalling Cutterhead Guard Installing Access Cover Installing Dust ChuteIf the access door latch needs adjustment Electrical ConnectionsOperation Jointing Warped Material Direction of GrainBevel Cut Taper CutRabbet Cut Removing and Replacing KnivesBlade Care Gib AdjustmentLubrication Sharpening the Knives Cutterhead RemovalTrouble Possible Cause Solution Trouble-shootingFence Assembly Parts List for the JJ-8CS Woodworking Jointer Fence Assembly Index Part Description Size QtyBed Assembly 16 x 1-1/4 Stand and Motor Assembly JC-M01W Cutterhead Assembly Cutterhead Assembly Wiring Diagram