
ASSEMBLING
MOTOR PULLEY
Assemble motor pulley (K) Fig. 10, to motor shaft with the hub of the pulley in the outer position as shown. Make certain key (L) is inserted in the keyway of the pulley and motor shaft, then tighten set screw (M) using the 3 mm hex wrench (not shown).
ASSEMBLING BELT AND ALIGNING PULLEYS
1.Place belt (A) Fig. 11, in groove of cutterhead pulley
(B) and motor pulley (C).
2.Make certain the motor pulley (C) Figs. 11 and 12, is properly aligned with cutterhead pulley (B) by placing a straight edge (D) Fig. 12, onto the face of each pulley as shown.
3.If an adjustment is needed, the motor pulley can be moved in or out on the motor shaft, or the motor can be shifted by loosening motor mounting screws, two of which are shown at (E) Fig. 12. After adjustments are made, tighten motor mounting hardware and motor pulley set screw.
ADJUSTING BELT TENSION
1.Correct belt tension is obtained when there is approximately 1" deflection at the center span of the belt using light finger pressure.
2.If an adjustment is required, the motor can be raised or lowered to obtain the correct belt tension.
3.Tighten motor mounting hardware after tension is applied, making sure alignment of the pulleys is not disturbed.
4.
ASSEMBLING CUTTERHEAD PULLEY GUARD/ CARRIAGE BRACKET
1.Position two alignment pins (A) Fig. 13, with two alignment holes (B) in jointer base.
K
L
M
Fig. 10
B
A
C
Fig. 11
B
D
AE
C
Fig. 12
A
B
B
C
A
Fig. 13
10