DeWalt 37-380 instruction manual Assembly, Jointer to Stand

	20
		27
16			33
	21
		28
	22
			34

23		29
	35
24			30
	36
25				31
	32
26

17

18 19

		Fig. 3
16.	Stand with Pre-Wired Switch	27.	3/8" Flat Washer (6)
17.	Dust Chute	28.	11/32" Flat Washer (1)
18.	V-Belt	29.	M8 Flat Washer (10)
19.	Pulley	30.	3/8" Lockwasher (3)
20.	3/8-16x2" Hex Head Screw (3)	31.	M8.1 Lockwasher (10)
21.	M8x1.25x55mm Hex Socket Head Screw (4)	32.	5/16" Lockwasher (1)
22.	M8x1.25x25mm Hex Socket Head Screw (2)	33.	M14x2 Hex Nut (1)
23.	M8x1.25x20mm Hex Socket Head Screw (2)	34.	3/8-16" Hex Nut (3)
24.	M8x1.25x16mm Hex Socket Head Screw (2)	35.	5/16-18 Hex Nut (1)
25.	5/16-18x1" Hex Head Screw (1)	36.	Key
26.	#10-16x1/2" Sheet Metal Screw (4)

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

JOINTER TO STAND

Your Jointer stand (A) Fig. 4, is shipped with the motor and switch completely wired.

NOTE: THE MOTOR IS BOLTED TO THE TOP OF THE STAND AND MUST BE ATTACHED TO THE MOTOR MOUNTING BRACKETS.

1.Remove the six screws (C) Fig. 4. Then remove back panel (E) from the stand.

C

E

C

Fig. 4

8