DeWalt 37-380 instruction manual Assembling Cutterhead Guard

2. Fig. 18 illustrates fence properly mounted.

3.Thread shorter fence handle (E ) Fig.19, into infeed end of fence (A) and longer fence handle (G) into outfeed end as shown.

ASSEMBLING CUTTERHEAD GUARD

1.Remove set screw (not shown) from cutterhead guard post (F) with the 2.5mm hex wrench. Insert post

(F) through hole in the infeed table. NOTE: A spring is supplied in knob assembly (E) that returns the guard (C) over the cutterhead after a cut has been made. Turn knob (E) counter-clockwise to provide tension on the spring before inserting post (F). Make certain the spring engages in the slot of the post. If spring tension is too tight or too loose, adjust the spring accordingly by removing the guard and rotating knob (E).

2.Thread set screw (B) Fig. 21 back into post (F) Fig. 20, to keep cutterhead guard (C) in position during jointer operation.

3.Fig. 21, illustrates the cutterhead guard (C) assembled to the infeed table.

Fig. 18

G

E

A

Fig. 19

C

F

E

Fig. 20

C

B

Fig. 21

12