DeWalt 37-380 instruction manual Jointer Parts

Page 7

JOINTER PARTS

1

3

4

2

5

6	7
	7
8

		10		11
				11
				12
	9					13
						13

	14				15
	14				15

							Fig. 2
1.	Jointer						9.	Push Blocks (2)
2.	Fence Carriage Assembly						10.	6mm Hex Wrench
3.	Cutterhead Pulley Guard/Carriage Mounting Bracket						11.	4mm Hex Wrench
4.	Table Raising Handle						12.	3mm Hex Wrench
5.	Switch Mounting Bracket						13.	2.5mm Hex Wrench
6.	Cutterhead Guard						14.	12-14mm Open End Wrench
7.	Fence Tilting Handles (2)						15.	8-10mm Open End Wrench
8.	Fence

7

Image 7

Contents Professional Jointer Important Safety Instructions Safety Guidelines DefinitionsStay ALERT, Watch What YOU are Doing Failure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules For JointersPower Connections Extension Cords Unpacking and CleaningJointer Parts Jointer to Stand AssemblyAssembling Infeed Table Adjustment Handle Assembling Cutterhead Pulley GUARD/ Carriage Bracket Adjusting Belt TensionAssembling Motor Pulley Assembling Belt and Aligning PulleysAssembling Fence Assembling Fence Carriage AssemblyAssembling Cutterhead Guard Assembling Dust Chute Assembling Switch and Mounting BracketStarting and Stopping Jointer Operating Controls and AdjustmentsLocking Switch OFF Position Infeed Table AdjustmentsS C O N N E C T M a C H I N E F R O M Power Source Outfeed Table AdjustmentsInfeed Table Positive Stops Knife Adjustments Adjusting Table Gibs Fence Operation Adjusting Fence Positive StopsRotate screw R until you are certain the fence REMOVING, REPLACING, and Resetting KnivesReplace cutterhead guard Never Pass Hands Directly Over the Cutterhead Placement of Hands During FeedingOperation Jointing AN EdgeCutting a Rabbet SurfacingBeveling Taper CutsDirection of Grain Maintenance and RepairsSurfacing Warped Pieces Surfacing Short Or Thin WorkConstructing a Push Stick PushstickPage Page PARTS, Service or Warranty Assistance AccessoriesCanadian PORTER-CABLE Delta Service Centers