Grizzly G0656 owner manual Squaring Stock, Surface Planing

Page 24

Squaring Stock

Squaring stock involves four steps performed in the order below:

1.Surface Plane On The Jointer—The con- cave face of the workpiece is surface planed flat with the jointer.

2.Surface Plane On a Thickness Planer—The opposite face of the workpiece is surface planed flat with a thickness planer.

Previously

Surface

Planed Face

3.Edge Joint On The Jointer—The concave edge of the workpiece is jointed flat with the jointer.

4.Rip Cut On A Table Saw—The jointed edge of the workpiece is placed against a table saw

fence and the opposite edge cut off.

Previously

Jointed Edge

��

��

��

Surface Planing

The purpose of surface planing on the jointer is to make one flat face on a piece of stock (see Figures 26 & 27). This is a necessary step when preparing a workpiece to be run through a planer when squaring stock.

NOTICE If you are not experienced with a jointer, set the depth of cut to 0", and practice feeding the workpiece across the tables as described. This procedure will better pre- pare you for the actual operation.

Figure 26. Typical surface planing operation.

Figure 27. Illustration of surface planing results.

-22-	G0656 8" Jointer with Built-In Mobile Base

Image 24

Contents Model G0656 Page Table of Contents Introduction ForewordContact Info Machine Data Sheet G0656 8 Jointer with Built-In Mobile Base Identification Safety Instructions for Machinery G0656 8 Jointer with Built-In Mobile Base Additional Safety Instructions for Jointers Circuit Requirements 220V OperationSetup Setup SafetyItems Needed for Setup UnpackingAssembly Fasteners Qty InventoryWood Crate Figure Qty Cardboard Box Figure QtyHardware Recognition Chart Clean Up Site ConsiderationsAssembly To assemble the jointerChecking belt alignment Cutterhead Pulley Motor Page Dust Collection Setting Outfeed To connect a dust collection hoseTo set the outfeed table height Recommended Adjustments Factory adjustments that should be verifiedTest Run Tighten V-BeltOperation Safety Jointer Overview OperationsBasic Controls Start Button Starts motorStock Inspection Requirements Scrape all glue off of boards before joint- ingSquaring Stock Surface PlaningEdge Jointing To surface plane on the jointerBevel Cutting To edge joint on the jointerRabbet Cutting To bevel cut on the jointerTo rabbet cut on the jointer Accessories H7765-8 Byrd Shelix CutterheadG3631-Jointer Knife Hone Dispoz-A-BladeHolder and Knife T20448T20452 T20501 T20456 H0736 Our most popular eye protectionMaintenance ScheduleLubrication Daily CheckCleaning To adjust/replace the V-beltBelts Service TroubleshootingCutting Setting/Replacing Knives Inspecting KnivesTools Needed Qty To inspect the knivesPage Setting Infeed Table Calibrating Depth ScaleSetting Fence Stops To set the 45˚ inward fence stopTo set the 90˚ fence stop Adjusting Gibs To adjust the table gibsTo set the 45˚ outward fence stop Wiring Diagram See FigureTable Parts Breakdown Table Parts List DescriptionFence Parts Breakdown Fence Parts List Stand Parts Breakdown Stand Parts List DescriptionLabel Placement Page Page Warranty and Returns