OPERATION
5.If the engine fails to start, DO NOT continue to rotate the ignition key for more than 5 seconds. Return the key to the RUN position and wait 10 seconds before starting again
Figure 17. Starter Switch (Option)
Figure 18. Engine Start Handle
4.Push down decompression lever (Figure 19) and release.
CAUTION
While the engine is running, never try to turn the ignition key to the START position.
6.After starting the engine, continue to warm up the engine for about 3 to 10 seconds especially in cold weather.
7.If the buzzer does not stop sounding after the engine has started, shutdown engine immediately and check engine oil level. The buzzer functions as a engine oil level alam warning device.
Figure 19. Decompression Lever
5.If the engine does not start, repeat steps 4 and 5.
TRAVELING
NOTICE
When starting a unit with an electric strart capability, a decompressor is not normally required.However,whenambient temperatureorbatterychargerlevelislow,useofadecompressor will help make the
Recoil Start
1.Open the fuel cock (Figure 15).
2.Move the throttle lever to the START position (Figure 16).
3.Grasp the starter grip (Figure 18) and slowly pull it out.The resistance becomes the hardest at a certain position, corresponding to the compression point. Pull the starter grip briskly and smoothly for starting.
CAUTION
Make sure to follow all safety rules referenced in the safety section of this manual before operating compactor. Keep work area clear of debris and other objects that could cause damage to the compactor or bodily harm.
1.Grasp the compactor's hand grip (Figure 20), and move the engine throttle lever (Figure 20) quickly to the fast position.
2.With the throttle lever in the fast position, the engine speed should be around 3,600 RPM, therefore engaging the cen- trifugal clutch
Figure 20. Throttle Lever (Fast)
MVH306D/DS PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #11 (02/04/14) — PAGE 19