Multiquip MVH-306DS manual Engine Oil Replacement, Air Filter Every 6 Months or 400 Hours

Page 22

MAINTENANCE

Engine Oil Replacement:

1.Replace engine oil, in first 25 hours of operation and every 50 to 100 hours afterwards.

2.Oil may be drained more easily when it is warm after operation (For more details, see separate engine Owner's Manual).

Air Filter (Every 6 Months or 400 Hours)

1.The air filter element should be cleaned because a clogged air cleaner can cause poor engine starting, lack of power and shorten engine life substantially.

Figure 25. Engine Air Filter and Element

2.To clean or replace air filter loosen the wing nut on the air filter housing (Figure 25) remove the cover and take out air filter cartridge. If only cleaning of the air filter is desired blow through the air filter cartridge from the inside, moving a jet of dry compressed air up and down until all dust is removed.

CAUTION

NEVERattempt to check theV-belt with the engine running. Severeinjurycan occurifyourhandgetscaughtbetweenthe V-belt and the clutch (Figure 26).Always use safety gloves.

CLUTCH

PULLEY

VIBRATOR

PULLEY

Figure 26 V-Belt Hazard

Checking and Replacing the V-Belt and Clutch

1.After 200 hours of operation, remove the belt cover to check the V-belt tension (Figure 27). Tension is proper if the belt bends about 3/8”(10 mm) when depressed strongly with finger between shafts.Loose or worn V-belts reduces power transmission efficiency, causing weak compaction and reduces the life of the belt itself.

Figure 27. V-Belt Check

Replacing the V-belt

Remove the belt cover. Engage an offset wrench 3/4”(19 mm) or the like to vibrator pulley (lower) fastening bolt. Engage waste cloth or the like at midway of V-belt on the left side and while pulling it back strongly, rotate the offset wrench clockwise so that the V-belt will come off.

Reinstalling the V-belt

Engage V-belt to lower vibrator pulley and push the V-belt to left side of upper clutch and, in the same manner as in removal, rotate offset wrench clockwise so that the V-belt goes back on.

Checking Clutch

Check the clutch simultaneously with V-belt checking. With belt cover removed, check outer drum of the clutch for seizure and "V" groove for wear or damage with your eyes. Clean the "V" groove as necessary. If the shoe is worn, power transmission becomes deficient and slipping will result.

Replacing Clutch

Remove V-belt. Remove bolt at engine power output by giving a light tap with a hammer to an engaged wrench and rotate bolt counterclockwise. Remove clutch with a pulley extractor. To reinstall, reverse the procedure.

CAUTION

Whenever the compactor's vibration becomes weak or lost during normal operation regardless of operation hours, check theV-belt and clutch immediately.

PAGE 22 — MVH306D/DS PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #11 (02/04/14)

Image 22
Contents Models MVH-306D Recoil Start MVH-306DS Electric Start Proposition 65 Warning Diesel engine exhaust and somePage Table of Contents Mikasa MVH-306D/DS Reversible Plate CompactorParts Ordering Procedures Ordering parts has never been easierSafety Information Safety MessagesGeneral Safety Compactor Safety Fuel Safety Transporting Safety Specifications MVH-306D/DS Reversible Plate Compactor SpecificationsDimensions MVH-306D/DS Reversible Plate Compactor DimensionsGeneral Information Components MVH-306D/DS Reversible Plate Compactor ComponentsBasic Engine Engine ComponentsChecking Engine Oil Level InspectionBefore Starting Checking the Hydraulic Oil LevelExplosive Fuel Checking The FuelStarting the Engine OperationReleasing the Handle Electric Start OptionTraveling Recoil StartNormal Shutdown Stowing the HandleInspection and Maintenance ServiceTables MaintenanceDaily Service Air Filter Every 6 Months or 400 Hours Engine Oil Replacement Reinstalling the V-belt  Checking ClutchDraining Hydraulic Oil Vibrator Oil Level CheckAdding Hydraulic Oil Bleeder Plug Battery Maintenance Option Battery ChargingLong Term Storage Battery Cable Connection OptionTroubleshooting Checking Fuel FilterTroubleshooting Engine TroubleshootingTroubleshooting Compactor Sample Parts List Explanation of Code in Remarks ColumnSuggested Spare Parts MVH-306W/YANMAR L-70EE Diesel EngineNameplate and Decals Nameplate and DecalsPart Name QTY Remarks Vibrating Plate Assy Part Name Base and Engine Assy Base & Engine Assy Base and Engine Assy Union TIP, Drain Vibrator Assy Vibrating Case Control Handle Assy Handle Bracket Control Handle Assy COLUMN, Handle Hand Pump Assy Accumlator Includes Items W/# Battery ASSY. Option CRADLE, Battery Electric Device Assy Battery Cord 400L Yanmar L-70EE Cylinder Block Assy COVER, Starter Yanmar L-70EE Cylinder Head and Cover Assy Cylinder Head & Cover Assy Yanmar L-70EE Muffler Assy Gasket NON ASB Yanmar L-70EE AIR Cleaner Assy COVER, AIR Cleaner Yanmar L-70EE CRANKSHAFT, PISTON, Camshaft Assy CRANKSHAFT, Piston & Camshaft Assy Yanmar L-70EE LUB OIL Pump and Governor Assy LUB. OIL Pump & Governor Assy Yanmar L-70EE Cooling and Starting Device Assy Cooling & Starting Device Assy Yanmar L-70EE Fuel Injection Pump Assy Plate Yanmar L-70EE Fuel Tank and Fuel Line Assy Fuel Tank & Fuel Line Assy Yanmar L-70EE Starting Motor and Dynamo Assy Starting Motor & Dynamo Assy Yanmar L-70EE TOOL, LABEL, and Gasket Assy TOOL, Label & Gasket SET Assy Terms and Conditions of Sale Parts Page HERE’S HOW to GET Help