
Always use a hold down or push block when surfacing short stock or stock less than 3 inches thick.
Figure 21
Rabbeting
A rabbet cut requires removal of the cutter guard. Use extreme caution and keep hands clear of cutterhead. Always replace guard immediately after rabbeting operation is completed.
A rabbet is a groove cut along the edge of a board. See Figure 22. The width and thickness of the wood to be rabbeted depends upon the width and length of the rabbet. However, never rabbet a piece of wood less than 12” long.
Figure 22
Use push blocks to rabbet cut whenever possible. The rabbeting capacity is 3/4”.
1.Disconnect machine from power source.
5.Set fence for desired width of rabbet.
6.Check width of the rabbet by measuring the distance from end of knife in the cutterhead to the fence.
7.Reconnect power. Lower infeed table 1/32” at a time and make successive cuts until the desired depth of rabbet has been obtained.
See Figure 22. NOTE: It is easier and safer to take a series of shallow cuts.
Jointing Warped Surfaces
If the wood to be jointed is dished or warped, take light cuts until the surface is flat. Avoid forcing such material down against the table; excessive pressure will spring it while passing the knives, and it will spring back and remain curved after the cut is completed.
Jointing Short or Thin Work
When jointing short or thin pieces, use a push block to eliminate all danger to the hands. Two push blocks are shipped with your jointer. You can also make your own easily from scrap material. Two types are shown in Figure 23.
Figure 23
Direction of Grain
Avoid feeding work into the jointer against the grain. This will result in chipped and splintered edges. See Figure 24. Feed with the grain to obtain a smooth surface, as shown in Figure 25.
Figure 24
Figure 25
14