Powermatic PJ1696 operating instructions Troubleshooting, Replacement Parts

Troubleshooting

Trouble			Probable Cause	Remedy
Finished	stock	is		Raise	outfeed	table	until it	is on	the
			Knife tip is higher than outfeed table.	same level with tip of knife. See page
concave on the end.
				11.
Back end	of stock	is	Knife tip is not leveled with outfeed	Adjust outfeed table to align with knife
thicker than front side.			table.	tip. See page 11.
Finished	stock	is		Raise tale ends by adjusting the screws
			Both tables have to much end fall.	at the	four corners		under	the tables.
concave in the middle.
				See Figure 28 below.
Two tables are not in				Adjust	using	the	screws	shown	in
				Figure 29. (Remove protective caps to
line.
				access screw).
Ends of finished stock			Table ends are raised higher than the	Lower	both	table	ends	with	the
are cut more than the
			middle.	adjustment screws. See Figure 28.
middle.

Figure 28 Figure 29

Replacement Parts

Replacement parts are listed on the following pages. To order parts or reach our service department, call 1- 800-274-6848, Monday through Friday (see our website for business hours, www.powermatic.com). Having the Model Number and Serial Number of your machine available when you call will allow us to serve you quickly and accurately.

17