Mounting the Router

See Figure 10

6.Mount the router with adapter base plate using the through holes in the tabletop. Assemble with 3 screws

(T) through tabletop and into the adapter base plate at position H. (The adapter base plate comes from the factory with the nuts pressed into it.) Tighten securely.

7.Mount the router with adapter base plate by putting the pan head screws (T) through the holes in the tabletop and router base. Tighten securely.

CAUTION:

Make sure the screws from router base plate are long enough to mount router securely. Replace if neces- sary.

2.Loosen knobs and slide fences so that notches in fence line up to clear mounting holes.

3.While holding router upside down, position it to the underside within the center ring of the table top.

4.Rotate router until the three mounting holes in router base line up with the three larger holes in the table top.

5.Insert three machine screws from router base plate through holes in tabletop and into router mounting holes. Tighten securely.

6.To securely mount Craftsman routers that use the E-hole pattern to the table top without using adapter plate (K), three 10 - 32 x 1/2" pan head screws and three SAE #10 washers are required (not provided).

NOTE: For ease of use, position the router so the ON-OFF switch is accessible from the front of the table.

T (3)

CAUTION:

Make sure the screws from router base plate are long enough to mount router securely. Replace if neces- sary.

NOTE: Screw from router base plate or 10 - 32 x 1/2" pan head screw and washer SAE #10 washer

Fig. 10

II.Mounting Routers with Three-Hole Base Plate (Hole Pattern "E")

See Figure 11
1. Remove router base plate from router by removing	Fig. 11
screws.