Ryobi A25RT02 manual PRE-DRILLING Holes for Through Table Depth Adjustment

ASSEMBLY

PRE-DRILLING HOLES FOR THROUGH TABLE DEPTH ADJUSTMENT

See Figure 8.

Since each router will have different placements for through table depth adjustments, pilot holes have been pre-drilled in the throat plate to assist in through table adjustments. Only the models listed below in the key are available for use with the through table depth adjustment feature.

Remove the throat plate.

Determine which router you have and find the pre-drilled pilot hole that matches your router. (Refer to the key be- low.)

Using a drill and drill bit, drill a hole through the pilot hole large enough for the depth adjustment tool (not included with router table, but may be included with your router) to pass though so through table depth adjustments can be made.

Figure 8 Key:

RD: RIDGID R2930

RY: Ryobi R163K

ML: Milwaukee 5615-20, 5616-20

PC1: Porter-Cable 890 Series

PC2: Porter-Cable 8529

ATTACHING THE ROUTER TO THE TABLE

For ease of use, assemble the router to the insert plate with the insert plate removed first, then install the insert plate/ router assembly into the router table.

ATTACHING THE ROUTER TO THE INSERT PLATE

See Figures 9 - 10.

Remove the insert plate.

Remove the subbase plate from the router.

Using the following chart for reference, and using one of the three included sets of three router insert plate screws, attach the router to the insert plate with the pilot holes facing the router and the notch in the insert plate facing the back of the router table.

NOTE: When attaching insert plate to the router, make sure the holes in the router base match up with the insert plate accurately and are not off-center.

INSTALLING THE ROUTER/INSERT PLATE ASSEMBLY

See Figure 11.

With the insert plate installed on the router, insert router and insert plate assembly into the router table with the notch in the insert plate facing the back of the router table toward the fence assembly.

Install the insert plate screws and leave loose until all adjustments have been made.

PRE-DRILLED		INSERT PLATE
PILOT HOLES		REAR SIDE
RD
ML		PC2
	PC1 PC1	RY
		Fig. 8
		INSERT PLATE
		FRONT SIDE
B4	NOTCH A1	A2
A6	B1
A5	B2
B3	A3
	A4
		Fig. 9
		ROUTER INSERT
		PLATE SCREWS

INSERT PLATE

Fig. 10

INSERT PLATE

SCREWS NOTCH

3

2

1 0

1

h

2

FEED	1
	0
DIRECTION	1

Fig. 11

12