P 14/ 14
Wiring diagram
Fig. D-6
TD0101F
110V for UK
Wiring around Holder arm
Guide Field lead wires (purple, orange) inside the rib of Holder arm to avoid pinching between Housing set (R) and Holder arm.
Holder arm
rib of Holder arm
Wiring of Field
lead wires
Fix Field lead wire (red) with
Lead wire holders on Switch.
Noise suppressor
Terminal block
110 - 127V area
Except UK
rib
rib
Wiring of Lead wire (orange)
of left Brush holder and Field lead wire (white)
Fix field Lead wire (white) with Lead wire holder and Ribs.
Field lead wire (white)
Lead wire (orange) | rib | |
of left Brush holder | ||
|
Route Lead wire (orange)
of left brush holder by ribs. Lead wire holder on
Switch
Wiring of Noise suppressor’s
Lead wires
Guide the Lead wires of Noise suppressor between ribs.
*Lead wire (white) to Switch
*Lead wire (black) to LED circuit
Rib
Noise suppressor is not used for some countries.
Put Insulated connector into the area which is surrounded by Ribs.
Line filter |
| |
(if used) |
| |
Wiring of Lead wire (brown or |
| |
black) of Power supply cord |
| |
Through the route between the following | Pass Lead wires of Power | |
ribs, guide the above lead wire to Switch. | ||
supply cord through Line filter | ||
* ribs for setting Noise suppressor | ||
if necessary. | ||
* ribs for setting Terminal block | ||
|