P 12/ 14
Wiring diagram
Fig. D-4
TD0101F
Argentine, Chile etc.
Wiring around Holder arm
Guide Field lead wires (purple, orange) inside the Rib of Holder arm to avoid pinching between Housing set (R) and Holder arm.
Holder arm
Rib of
Holder arm
Wiring of Lead wire (orange)
of left Brush holder and Field lead wire (white)
Guide field Lead wire (white) between Lead wire holder and Ribs.
Field lead wire (white)
Wiring of Field
lead wires
Fix Field lead wires (red, clear) with Lead wire holders on Switch.
Noise suppressor
Terminal block
220-240V area except Argentine, Chile etc.
Rib
Rib
Lead wire (orange) | Rib | |
of left Brush holder | ||
|
Guide Lead wire (orange)
of left brush holder by Ribs. Lead wire holder on
Switch
Wiring of Noise suppressor’s
Lead wires
Guide the Lead wires of Noise suppressor between Ribs.
*Lead wire (black) to Switch
*Lead wire (black) to LED circuit
*Lead wire (clear) to Field
Rib |
Noise suppressor is not used for some countries.
Put Insulated connector into the area which is surrounded by Ribs.
LED Circuit
Wiring of Lead wire (brown or black) of Power supply cord
Through the route between the following ribs, guide the above lead wire to Switch.
*Ribs for setting Noise suppressor
*Ribs for setting Terminal block