Makita 6940D Installing or removing driver bit or socket bit, Adjusting the angle head

001266

12 mm	9 mm
(15/32”)	(3/8”)

Installing or removing driver bit or socket bit

Use only the driver bit or socket bit shown in the figure. Do not use any other driver bit or socket bit.

002824	To install the bit, pull the sleeve in the direction of the arrow
1	and insert the bit into the sleeve as far as it will go. Then
	release the sleeve to secure the bit.
	To remove the bit, pull the sleeve in the direction of the arrow
	and pull the bit out firmly.
2	NOTE:
	• If the bit is not inserted deep enough into the sleeve, the
1. Bit
	sleeve will not return to its original position and the bit
2. Sleeve
	will not be secured. In this case, try re-inserting the bit
	according to the instructions above.

002826

1

2

1.Hex bolt

2.Angle head

002827

1

2

1.Groove

2.Tooth

Adjusting the angle head

The angle head can be adjusted 360° (8 positions in 45- degree increments). To adjust it, loosen the hex bolt and remove the angle head.

Adjust the angle head to the desired position and reinstall it so that the teeth on the housing will match up with the grooves in the angle head. Then tighten the hex bolt to secure the angle head.

10