Makita 6940D instruction manual 100 150

Page 5

IMPORTANT SAFETY INSTRUCTIONS FOR

CHARGER & BATTERY CARTRIDGE

USC001-3

1. SAVE THESE INSTRUCTIONS - This man- 6. ual contains important safety and operat-

ing instructions for battery charger.

To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.

2.Before using battery charger, read all instructions and cautionary markings on

(1)battery charger, (2) battery, and (3) product using battery.

3.CAUTION - To reduce risk of injury, charge only MAKITA rechargeable batteries marked on the charger label. Other types of batteries may burst causing personal injury and damage.

4.Do not expose charger to rain or snow.

5.Use of an attachment not recommended or sold by the battery charger manufac- turer may result in a risk of fire, electric shock, or injury to persons.

7.Make sure cord is located so that it will not be stepped on, tripped over, or other- wise subjected to damage or stress.

8.An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure:

a.That pins on plug of extension cord are the same number, size, and shape as those of plug on charger;

b.That extension cord is properly wired and in good electrical condition;

c.That wire size is at least as large as the one specified in the table below.

Table 1: RECOMMENDED MINIMUM AWG SIZE FOR EXTENSION CORDS FOR BATTERY CHARGERS

Length of Cord (Feet)

25

50

100

150

 

 

 

 

 

AWG Size of Cord

18

18

18

16

 

 

 

 

 

9.Do not operate charger with damaged cord or plug - replace them immediately.

10.Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman.

11.Do not disassemble charger or battery cartridge; take it to a qualified serviceman when service or repair is required, Incor- rect reassembly may result in a risk of electric shock or fire.

12.To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning off con- trols will not reduce this risk.

13.The battery charger is not intended for use by young children or infirm persons without supervision.

14.Young children should be supervised to ensure that they do not play with the bat- tery charger.

15.If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possi- ble burns and even an explosion.

16.If electrolyte gets into your eyes, rinse them out with clear water and seek medi- cal attention right away. It may result in loss of your eyesight.

5

Image 5
Contents Cordless Angle Impact Driver Specifications Electrical Safety Specific Safety Rules 100 150 Additional Safety Rules for Charger Battery Cartridge Charging Installing or removing battery cartridgeFunctional Description Trickle charge Maintenance charge Switch action AssemblyReversing switch action Electric brakeAdjusting the angle head Installing or removing driver bit or socket bitOperation Straight head and ratchet head optional accessoryRecycling the Battery MaintenanceAccessories Memo Memo Memo Makita U.S.A., Inc Mail this Portion Factory Service Centers Makita Limited ONE Year Warranty