Chauvet DVM-HR Important Safety Information, Protection against Electric Shock, Before You Begin

Page 4

Before You Begin

Important Safety Information

This product is designed for professional use. This product presents risks of lethal or severe injury due to fire and heat, electric shock, and injury from falls. Read this manual before installing or powering the fixture, follow the safety precautions listed below and observe all warnings in this manual and on the fixture. If you have any questions about how to operate the fixture safely, please contact CHAUVET.

Protection against Electric Shock

Always disconnect from AC power source before servicing or replacing LED clusters or fuse, and be sure to replace with same type fuse.

All fixtures must be connected to circuits with a suitable Earth Ground.

Do not operate the fixture if covers are open or if any internal component is missing or damaged.

Make sure power cord is never crimped or damaged.

Never disconnect power cord by pulling or tugging on the cord.

Protection against Fire & Burns

Always make sure that you are connecting to the proper voltage and that the line voltage you are connecting to is not higher than that stated on decal or rear panel of the fixture.

The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces. Be sure that no ventilation slots are blocked.

Maintain a minimum distance of 1 meter (3.28 feet) from combustible materials.

Allow this product to cool for a minimum of 15 minutes before opening, handling or removing the cover in this product.

Maximum ambient temperature is Ta: 40°. Do not operate fixture at temperatures higher than this.

Protection against Injury to persons

Secure fixture to fastening device using a safety chain.

Do not open fixture for a minimum of 15 minutes after switching off.

In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center. Always use the same type spare parts.

DV Wall System User Manual

4

2007-02-05/16:45

Image 4
Contents DVM-HR Table of Contents Before You Begin Unpacking InstructionsContact Us Your shipment may include the followingImportant Safety Information Protection against Electric ShockProtection against Fire & Burns Protection against Injury to personsFeatures IntroductionOverview Computer System RequirementsProduct Overview IntroductionDV Wall 1024 Panel Square panels = 1 square meter 2007-02-05/1645Hardware Setup AC PowerPower Cable Configuration ResolutionMaximum System Configuration Other Configuration ExamplesD16 D14Setup Mounting SystemFlying bracket attachment Joining bracketM10 Hex bolts Hanging eye hookSignal & Power Configuration Each DV Wall panel consumes 109W of powerDV-Wall Driver J10 J11 J12 J13 J14 J15 J16 Rear View Panels = 1 meter²Dipswitch Settings JP1 DipswitchJP1 Dipswitches Default Off Default On SubtractJP2 Dipswitch Horizontal LineData Out 1 & Data Out 2 connectors DC External Power InputTransmitter Card Installation Transmitter CardExample System Configurations Aspect RatioMeters by 3 meter Meters by 6 metersMeters by 12 meters Front View J9Meters by 4.5 meters Meters by 9 metersSpecial Applications PatternReturns Procedure MaintenanceAppendix ClaimsTechnical Specifications per panel Technical Support