Charging the Battery Pack

Charger (36)

Adapter (37)

LED Light

Flanges

Figure 2

1.Plug the Adapter (37) into a 120V wall outlet.

Battery Pack (35)

Charger (36)

4.Charge for 2-1/2 to 3 hours, then unplug the Adapter from the wall and the Charger, and remove the Charger from the Battery Pack.

5.Allow the components to cool if they are warm or hot to the touch. Store the Adapter and Charger in the Storage Case (38).

CAUTION: Do not leave the Battery Pack charging for more than 5 hours or the Battery Pack may become damaged.

Note: Initial charge and recharging is approximately the same amount of time.

Flange

Figure 3

2.Align the flanges on the Charger (36) with the slots on the Battery Pack (35) and slide the Charger onto the Battery Pack.

Work Piece and Work Area Set Up

1.Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent distraction and injury.

2.Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.

3.There must not be objects, such as utility lines, nearby that will present a hazard while working.

Battery Pack (35)

Adapter (37)

Charger (36)

Adapter

Cord

Figure 4

3.Plug the Adapter cord into the Charger. The light on the Charger will turn on, indicating that the Battery Pack is Charging.

•Do not use sockets with drives smaller than 1/2”. You may use impact socket adapters to use impact sockets with drives greater than 1/2”.

•Do not exceed recommended bolt capacity of 1/2”

•To lock the Trigger (27), center the

Forward/Reverse Lever (26) on the tool.

Page 9