•To set the Impact Anvil (6) to turn forward (clockwise), press the right side of the Forward/Reverse Lever (26) until it clicks into place.
•To set the Impact Anvil (6) to turn in Reverse (counterclockwise), press the left side of the Forward/Reverse Lever
(26)until it clicks into place.
CAUTION: To prevent possible gear damage, always allow the Impact Anvil (6) to come to a complete stop before changing the direction of rotation.
Basic Operation
1.Charge the Battery Pack, but do not attach it to the Impact Wrench yet.
2.Center the Forward/Reverse Lever (26) to lock the Trigger (27).
3.Slide the desired socket (sold separately) onto the Impact Anvil (6).
Impact Wrench
Battery Pack (35)
Flange
Figure 5
4.Align the flanges on the bottom of the
Impact Wrench with the slots on the Battery Pack (35), and slide the Impact Wrench onto the Battery Pack.
5.Set the desired direction of the Impact
Anvil (6) with the Forward/Reverse Lever
(26).
6.Position the socket over the fastener.
7.Holding the handle firmly with one hand and the top of the Housing (24 & 28) with your other hand, gently squeeze the
Trigger (27).
Note: This tool has a variable speed and torque. Squeezing the Trigger more tightly will increase the speed and torque of the tool.
8.After tightening a fastener, check the torque with a torque wrench to make sure the fastener is secure.
9.When finished using the Impact Wrench, center the Forward/Reverse Lever (26).
10.To remove the Battery Pack (35), press in on both buttons on the side of the Battery Pack and slide the Impact Wrench off of the Battery Pack.
11.Store the tool and Battery Pack (35) in it’s Storage Case (38), away from children.
“Breaking Loose” Fasteners
To loosen a fastener which has become “frozen”, typically due to corrosion:
1.Spray silicon or another appropriate lubricant (sold separately) on the fastener and allow it to sit for
2.Position the socket over the fastener, then operate the Impact Wrench for short intervals, first in one direction, then the other direction to loosen the bolt. Be sure to let the Impact Anvil (6) come to a compete stop, before changing the direction of rotation.
Page 10 | For technical questions, please call | SKU 67845 |