Functional Description, Specifications | Harbor Freight Tools 65161

Save these instructions.

Functional Description

Specifications

Maximum Air Pressure	90 PSI
Air Inlet	1/4” -18 NPT
Maximum Torque
65159 1/4” Air Ratchet	40 ft-lbs.
65160 1/2” Air Ratchet	140 ft-lbs.
65161 3/8” Air Ratchet	100 ft-lbs.
Average Air Consumption
65159 1/4” Air Ratchet	3 CFM @ 90 PSI
65160 1/2” Air Ratchet	6 CFM @ 90 PSI
65161 3/8” Air Ratchet	6 CFM @ 90 PSI

Air Supply

To prevent explosion:

Use only clean, dry, regulated, compressed air to power this tool. Do not use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.

Initial Tool Set Up/

Assembly

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.

Unpacking

When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown throughout the manual as soon as pos- sible.

•This air tool may be shipped with a protective plug covering the air inlet. Remove this plug before set up.

1.Incorporate an in-line oiler, shut-off valve, regulator with pressure gauge, and filter for best service, as shown in the diagram above. An in-line shut- off valve is an important safety device because it controls the air supply even if the air hose is rup- tured.

Note: If an automatic oiler system is not used, add a few drops of Pneumatic Tool Oil to the airline connection be- fore operation. Add a few more drops after each hour of continual use.

2.Attach an air hose to the compres- sor’s air outlet. Connect the air hose to the air inlet of the tool. Other com-

SKU 65159 60 61 For technical questions, please call 1-800-444-3353.

Page 6