AMD GA-7VASFS-FS user manual Mpd+

Page 24

English

9) RAM_LED

Do not remove memory modules while DIMM LED is on. It might cause short or other unexpected damages due to the 2.5V stand by voltage. Remove memory modules only when AC Power cord is disconnected.

+

-

FS

10) PWR_LED

PWR_LED is connect with the system power indicator to indicate whether the system is on/off. It will blink when the system enters suspend mode. If you use dual color LED, power LED will turn to another color.

	Pin No.	Definition
1	1	MPD+
1	2	MPD-
	3	MPD-

FS

GA-7VASFS-FS Motherboard

- 24 -

Image 24

Contents GA-7VASFS-FS Table of Content Table of Content Installing the motherboard to the chassis… Introduction Bios GA-7VASFS-FS Motherboard Layout Block Diagram English Hardware Installation Process StepInstall the Central Processing Unit CPU CPU Installation CPU Heat Sink Installation Install memory modules DDR Introduction Install expansion cards PS/2 Keyboard and PS/2 Mouse Connector Yieee 1394 and USB ConnectorZParallel Port, Serial Port and Spdif Port LPT/COMA/SPDIF USB & LAN Connector \ Audio Connectors12 BAT AuxinFUSB1/FUSB2 16 F1394ATX12V +12V Power Connector ATX ATX Power Cpufan CPU FAN Connector Sysfan System FAN ConnectorPwrfan Power Fan Connector IDE1/ IDE2 IDE1/IDE2 ConnectorFDD Floppy Connector SATA0/SATA1 Serial ATA ConnectorMPD+ Fpanel 2x10 pins connector BAT Battery Faudio Faudio ConnectorAuxin AUX In Connector USB1 / FUSB2 Front USB Connector, Yellow16 F1394 Ieee 1394 Connector Sirq Serial IRQ ConnectorCI Case Open Clrcmos Clear Cmos jumperEnglish Bios Setup Status Page Setup Menu / Option Page Setup Menu Standard Cmos FeaturesAdvanced Bios Features Main MenuPower Management Setup PnP/PCI ConfigurationsLoad Fail-Safe Defaults Load Optimized DefaultsStandard Cmos Features DateTime IDE Primary Master, Slave / IDE Secondary Master, Slave Acoustic ManagementDriveA / Drive B Floppy 3 Mode Support for JapanArea Halt onMemory Advanced Bios Features Base MemoryExtendedMemory First / Second / Third Boot Device Password CheckFull Screen Logo Show Integrated Peripherals OnChip IDE Channel0OnChip IDE Channel1 OnChip SerialATA AC97AudioMC97Modem USB 1.1 ControllerParallel Port Mode USB Mouse SupportOnboard H/W LAN Onboard H/WPower Management Setup Acpi Suspend TypeUSB Device Wake-up From S3 Soft-Off by PwrbtnKeyboard Power On Mouse Power OnResume by Alarm AC Back FunctionPnP/PCI Configurations Current System/CPU Temperature Current CPU/SYSTEM/POWER FAN Speed RPMPC Health Status Current Voltage V Vcore / +3.3V / +5V / +12V /5VSBFrequency/Voltage Control Dram Clock MHzLoad Fail-Safe Defaults Load Fail-Safe Defaults? Y/N?YLoad Optimized Defaults Set Supervisor/User Password Enter PasswordSave & Exit Setup Save to Cmos and Exit Y/N? YExit Without Saving Quit Without Saving ? NEnglish