AMD GA-7VASFS-FS user manual Bios

Page 6

English

Hardware Monitor

y CPU/Power/System Fan Revolution detect

 

y CPU/Power/System Fan Fail Warning

 

y

CPU Overheat Warning

 

y

System Voltage Detect

 

 

On-Board Sound

y Realtek ALC655 CODEC

 

y Line Out / 2 front speaker

 

y Line In / 2 rear speaker(by s/w switch)

 

y Mic In / center& subwoofer(by s/w switch)

 

y AUX_In

 

 

On-Board LAN

y Build in RTL8101L Chipset

On-Board IEEE1394

y VT6307

PS/2 Connector

y PS/2 Keyboard interface and PS/2 Mouse interface

BIOS

y Licensed AWARD BIOS

 

y Supports Q-Flash

 

 

Additional Features

y PS/2 Keyboard power on by password

 

y PS/2 Mouse power on

y STR(Suspend-To-RAM) y AC Recovery

y USB KB/Mouse wake up from S3

yAcoustic Management for hard drive and optical drive

Please set the CPU host frequency in accordance with your processor's specifications. We don't recommend you to set the system bus frequency over the CPU's specification because these specific bus frequencies are not the standard specifications for CPU, chipset and most of the peripherals. Whether your system can run under these specific bus frequencies properly will depend on your hardware configurations, including CPU, Chipsets,SDRAM,Cards...etc.

GA-7VASFS-FS Motherboard

- 6 -

Image 6
Contents GA-7VASFS-FS Table of Content Table of Content Installing the motherboard to the chassis… Introduction Bios GA-7VASFS-FS Motherboard Layout Block Diagram English Hardware Installation Process StepInstall the Central Processing Unit CPU CPU Installation CPU Heat Sink Installation Install memory modules DDR Introduction Install expansion cards PS/2 Keyboard and PS/2 Mouse Connector Yieee 1394 and USB ConnectorZParallel Port, Serial Port and Spdif Port LPT/COMA/SPDIF USB & LAN Connector \ Audio ConnectorsFUSB1/FUSB2 12 BATAuxin 16 F1394ATX12V +12V Power Connector ATX ATX PowerCpufan CPU FAN Connector Sysfan System FAN ConnectorPwrfan Power Fan Connector IDE1/ IDE2 IDE1/IDE2 ConnectorFDD Floppy Connector SATA0/SATA1 Serial ATA ConnectorMPD+ Fpanel 2x10 pins connector BAT Battery Faudio Faudio ConnectorAuxin AUX In Connector USB1 / FUSB2 Front USB Connector, Yellow16 F1394 Ieee 1394 Connector Sirq Serial IRQ ConnectorCI Case Open Clrcmos Clear Cmos jumperEnglish Bios Setup Advanced Bios Features Status Page Setup Menu / Option Page Setup MenuStandard Cmos Features Main MenuLoad Fail-Safe Defaults Power Management SetupPnP/PCI Configurations Load Optimized DefaultsStandard Cmos Features DateTime IDE Primary Master, Slave / IDE Secondary Master, Slave Acoustic ManagementDriveA / Drive B Floppy 3 Mode Support for JapanArea Halt onMemory Advanced Bios Features Base MemoryExtendedMemory First / Second / Third Boot Device Password CheckFull Screen Logo Show Integrated Peripherals OnChip IDE Channel0OnChip IDE Channel1 MC97Modem OnChip SerialATAAC97Audio USB 1.1 ControllerOnboard H/W LAN Parallel Port ModeUSB Mouse Support Onboard H/WUSB Device Wake-up From S3 Power Management SetupAcpi Suspend Type Soft-Off by PwrbtnResume by Alarm Keyboard Power OnMouse Power On AC Back FunctionPnP/PCI Configurations PC Health Status Current System/CPU TemperatureCurrent CPU/SYSTEM/POWER FAN Speed RPM Current Voltage V Vcore / +3.3V / +5V / +12V /5VSBFrequency/Voltage Control Dram Clock MHzLoad Fail-Safe Defaults Load Fail-Safe Defaults? Y/N?YLoad Optimized Defaults Set Supervisor/User Password Enter PasswordSave & Exit Setup Save to Cmos and Exit Y/N? YExit Without Saving Quit Without Saving ? NEnglish