Parkside PLS 48 A1 manual Solder sponge, Soldering

Page 14

Using the product

Setting 5 = 500 °C maximum soldering temperature, e.g. for desolder- ing large soldered joints

Switching off:

Note: After use always replace the soldering pencil Press the ON / OFF switch 2 into setting “0”.

1

into the holder.

If the device is not being used, pull the mains lead out of the mains socket.

Overheating protection:

This device has overheating protection. This is triggered by the device reaching too high a temperature. The ﬂow of current is interrupted. The device switches oﬀ and the ON / OFF switch 2 light ceases to illuminate. The device is ready for use again after approximately 10 minutes. The ON / OFF switch 2 light illuminates again.

Solder sponge

CAUTION! The hot soldering tip 7 must never be placed in contact with a dry solder sponge 5 , otherwise the solder sponge may be damaged.

The solder sponge 5 is used to clean soldering tips.

Moisten the solder sponge 5 before you use it.

Soldering

—The soldering pencil has a rated output of 48 watts and is therefore ideal for electronics soldering (see Figs. A, B).

—The design of the soldering pencil makes it especially suitable for use where access is diﬃcult or for ﬁne soldering work.

GB/IE 15

Image 14

Contents Soldering Station PLS 48 A1 GB / IE Page Using the product Table of contents IntroductionSafety advice Before first useVolt AC Risk of explosionRisk of ﬁre Soldering station PLS 48 A1 Introduction Proper useTechnical information Features and equipmentIncluded items Workplace safety Electrical safetyPersonal safety Safety advice Careful handling and use of electrical power tools Always wash your hands immediately after solderingBefore ﬁrst use Safety advice / Before first useOriginal accessories / attachments Inserting / replacing soldering tipsSwitching on / oﬀ and setting the temperature Solder sponge SolderingClean the soldering tip 7 on the moist solder sponge Using the product / Maintenance and cleaningMaintenance and cleaning Service centre Warranty Maintenance and cleaning / Service centre / WarrantyWarranty / Disposal DisposalDisposal / Declaration of conformity / Producer 20 GB/IE Vor der Inbetriebnahme Inhaltsverzeichnis EinleitungSicherheitshinweise InbetriebnahmeWarnung vor heißen Oberﬂächen ExplosionsgefahrBrandgefahr Volt WechselspannungRegelbare Lötstation PLS 48 A1 Einleitung Bestimmungsgemäßer GebrauchTechnische Daten AusstattungLieferumfang Gerät verlieren ArbeitsplatzElektrische Sicherheit Vermeiden Sie Lebensgefahr durch elektrischen SchlagSicherheit von Personen Sicherheitshinweise Verwendung und Behandlung des Elektrowerkzeugs Lötabfälle gehören zum SondermüllWechseln Sie die Lötspitze indem Sie diese herausdrehen Originalzubehör / -zusatzgeräteLötspitzen einsetzen / wechseln Gehen Sie hierfür wie folgt vor Vor der Inbetriebnahme / InbetriebnahmeEin- / ausschalten und Temperatur einstellen Einschalten und Temperatur einstellenLötschwamm ÜberhitzungsschutzLöten Garantie Wartung und Reinigung / Service / GarantieService 34 DE/AT/CH Entsorgung Garantie / Entsorgung / Konformitätserklärung / Hersteller36 DE/AT/CH Kompernass Gmbh