Parkside PLS 48 A1 manual Personal safety

Page 9

Safety advice

c)Use a residual current device (RCD) for protection if operating the electrical power tool in a moist envi- ronment is unavoidable. The use of an RCD reduces the risk of electric shock.

d)Do not use the mains lead for any purpose for

which it was not intended, e.g. to carry the device, to hang up the device or to pull the mains plug out of the mains socket. Keep the mains lead away from heat, oil, sharp edges or moving parts of the device. Damaged or tangled mains leads increase the risk of electric shock.

e)Do not operate the device if the mains lead or mains plug is damaged.

WARNING! A damaged mains lead presents a serious danger to life from electric shock.

f)Always keep the mains lead out of the operating area and run it away from the rear of the device.

g)Always pull out the mains plug if you are about to leave the device unattended or wish to carry out any tasks on the device.

3. Personal safety

a)Children or persons who lack the knowledge or ex- perience to use the device or whose physical, sensory or intellectual capacities are limited must never be allowed to use the device without supervision or in- struction by a person responsible for their safety. Children must never be allowed to play with the device.

b)Remain alert at all times, watch what you are doing and always proceed with caution. Do not use the device if you are tired or under the influence of

10 GB/IE

Image 9
Contents Soldering Station PLS 48 A1 GB / IE Page Safety advice Table of contents IntroductionUsing the product Before first useRisk of explosion Risk of fireVolt AC Proper use Soldering station PLS 48 A1 IntroductionFeatures and equipment Included itemsTechnical information Electrical safety Workplace safetyPersonal safety Safety advice Always wash your hands immediately after soldering Careful handling and use of electrical power toolsOriginal accessories / attachments Safety advice / Before first useBefore first use Inserting / replacing soldering tipsSwitching on / off and setting the temperature Soldering Solder spongeUsing the product / Maintenance and cleaning Maintenance and cleaningClean the soldering tip 7 on the moist solder sponge Maintenance and cleaning / Service centre / Warranty Service centre WarrantyDisposal Warranty / DisposalDisposal / Declaration of conformity / Producer 20 GB/IE Sicherheitshinweise Inhaltsverzeichnis EinleitungVor der Inbetriebnahme InbetriebnahmeBrandgefahr ExplosionsgefahrWarnung vor heißen Oberflächen Volt WechselspannungBestimmungsgemäßer Gebrauch Regelbare Lötstation PLS 48 A1 EinleitungAusstattung LieferumfangTechnische Daten Elektrische Sicherheit ArbeitsplatzGerät verlieren Vermeiden Sie Lebensgefahr durch elektrischen SchlagSicherheit von Personen Sicherheitshinweise Lötabfälle gehören zum Sondermüll Verwendung und Behandlung des ElektrowerkzeugsOriginalzubehör / -zusatzgeräte Lötspitzen einsetzen / wechselnWechseln Sie die Lötspitze indem Sie diese herausdrehen Ein- / ausschalten und Temperatur einstellen Vor der Inbetriebnahme / InbetriebnahmeGehen Sie hierfür wie folgt vor Einschalten und Temperatur einstellenÜberhitzungsschutz LötschwammLöten Wartung und Reinigung / Service / Garantie ServiceGarantie 34 DE/AT/CH Garantie / Entsorgung / Konformitätserklärung / Hersteller Entsorgung36 DE/AT/CH Kompernass Gmbh