Powermatic PM15 operating instructions Introduction Specifications, Turn = 1/16

Page 6

Introduction

This manual is provided by Walter Meier (Manufacturing) Inc. covering the safe operation and maintenance procedures for a Powermatic Model PM15 Planer-Molder. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or Walter Meier. Walter Meier can also be reached at our web site: www.waltermeier.com.

Specifications

 

Model Number

PM15

Stock Number

1120003

Table overall size (in.)

27-1/2 x 15-1/8

Table Height Adjustment (in.)

1 Turn = 1/16

Maximum cutting width (in.)

15

Maximum thickness (in.)

6-1/2

Minimum thickness (in.)

3/16

Maximum depth of cut – Planing (in.)

1/8

Maximum depth of cut – Molding (in.)

3/4

Minimum workpiece length (in.)

8

Number of planing knives

3

Urethane feed rollers diameter (in.)

1-1/2

Cutterhead speed (RPM)

4500

Cuts per minute

13,500

Cutterhead diameter (in.)

2-7/8 (3” with planing knives installed)

Feed rates (FPM)

10 and 20

Dust Port Diameter (in.)

4

Dust Collection Minimum CFM Required

900

Overall dimensions (LxWxH)(in.)

28 x 34 x 51

Motor

TEFC, 5HP, 1PH, 230V only, 60Hz

Net Weight (lbs.)

423

Shipping weight (lbs.)

550

The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, Walter Meier reserves the right to change specifications at any time and without prior notice, without incurring obligations.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Walter Meier Manufacturing Inc Part No. M-0460264Warranty and Service More Information Table of Contents Page Page Introduction Specifications Turn = 1/16Installation and Assembly Contents of the Shipping ContainerUnpacking Installing Dust Chute Installing HandwheelElectrical Connections Extension Cords AdjustmentsPlaner Knife Replacement Belt TensionSharpening Knives Planer’s Feed System Depth of CutFeed Rate Anti-Kickback FingersInfeed Roller Chipbreaker Leveling Cutterhead with Bed Caster Lock Interlock SwitchOperation Kinds of WarpPlaning to Desired Thickness Thickness Planing StepsPattern Knives Introduction to MoldingPlaning for Finish Optional Bedboard and GuideHomemade Featherboard Installing Single Pattern KnivesHomemade Bedboard Homemade Guide Set-Up for Edge MoldingInstalling Three-Knife Set Pattern Knife ClearanceInstalling Bedboard Face Molding with pattern knivesEdge Planing Bedboard must be installed on the planer when edge planingEdge Molding with pattern knives Common Molding ApplicationsRabbet Maintenance LubricationTrouble Probable Cause RemedyOne cause of overload trips which is Trouble Probable Cause Remedy Troubleshooting Operating Problems Replacement Parts Parts List Base Assembly Index No Description Size QtyBase Assembly Parts List Gearbox Assembly Index No. Part No Description Size QtyGearbox Assembly Parts List Stand Assembly Stand Assembly Parts List Cutterhead, Hood and Table Assembly PM15-HP Cutterhead, Hood and Table Assembly Electrical Connections Page New Sanford Road LaVergne, Tennessee Phone
Related manuals
Manual 6 pages 40.8 Kb
Top Page Image Contents