Unpacking
Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not discard any shipping material until the Planer/Molder is assembled and running properly.
Compare the contents of your container with the following parts list to make sure all parts are intact. Missing parts, if any, should be reported to your distributor. Read the instruction manual thoroughly for assembly, maintenance and safety instructions.
Contents of the Shipping Container
Refer to Figure 1.
1Planer/Molder (not shown)
1Dust Chute – A
1Dust Hood – B
1Straight Knife Setting Gauge Assy. – C
1Handwheel – D
1Handle – E
3Knife Gibs – F
8Phillips Pan Head Screws, M6x12 – G
8Flat Washers, M6 – H
1Socket Head Cap Screw, M6 x 15 - J
1Lock Washer, M6 – K
1Flat Washer, M6 – L
1Reversible Screwdriver – M
1Brass Punch – N
2
1Hex Wrench Set (3,4,5,6 mm) – P
1
1Spanner Wrench – S
1Molding Knife Gauge – T
1Owner's Manual (not shown)
1Warranty Card (not shown)
Items E through S comprise hardware package, stock no.
Installation and Assembly
Tools required:
10, 11 and 13mm wrenches
Remove the screws holding the base of the machine to the skid, and lift the planer/molder off the skid.
The machine area should be clean, dry, well ventilated, and well lighted. Since planers can create noise problems, the site selection should be one which minimizes reverberant sound from walls, ceilings and other equipment. The machine’s wheels should be in the locked position prior to use.
Figure 1
7