English
Carton Contents
1Rolling miter saw/planer stand
1Leg extension
1Storage foot
2Wheel/storage foot connector (left and right)
2Extension work support assembly
1Handle
2 Wheel
2 Axle
2 Work support arms (1 with black cap)
1Hardware bag:
2 Cord wrap brackets (L, R)
6 M8 x 15 mm buttonhead screws
1 M8 x 25 mm buttonhead screw
6 Curved washers
2 Extension locking knobs
1 M8 lock washer
1 M6 x 10 mm button head screw
1 M6 lock washer
1 Hex wrench
Tools Required
•Hex wrench (supplied)
•Adjustable crescent wrench
•1/2 inch open end wrench
•3/4 inch open end wrench
UNPACKING AND CLEANING
Carefully unpack the product and all loose items from the shipping container(s). Remove the
using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
NOTICE: Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your stand.
Components (Fig. 1)
WARNING: Never modify the stand or any part of it. Damage or personal injury could result.
Refer to Figure 1 for Components List.
ASSEMBLY
WARNING: PINCH HAZARD. To reduce the risk of serious personal injury, do not raise or lower stand until the assembly of the extension work supports is complete.
WRENCH STORAGE (FIG. 3)
The supplied hex wrench (J) comes in the wrench storage location in the corner of the stand.
ATTACHING THE LEG EXTENSION (FIG. 2, 3)
IMPORTANT: Place stand upside down on the floor or on a level, stable table as shown in Figure 2.
FIG. 2
2
