DeWalt DWX726 instruction manual English

English

WARNING: Planers MUST be mounted in the orientation shown in Figure 16.

FIG 16

WARNING: The cuttinghead MUST be raised on all miter saws, compound miter saws and sliding compound miter saws. All sliding compound miter saws MUST be locked in the rear position. Failure to do so may result in serious personal injury.

WARNING: STABILITY HAZARD. Stay alert. The stand may tip during this procedure. Serious injury may result.

1.Ensure the tool is securely mounted to the stand and is turned off and disconnected from power source.

2.Place a 2-1/2 inch (63.5 mm) thick block of wood (FF) under the front leg (GG) of the stand so that the front leg is raised 2-1/2 inches (63.5 mm) off the floor.

FIG 17

GG

HH

FF

WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before installing and removing accessories, before adjusting or changing set- ups or when making repairs. An accidental start-up can cause injury.

WARNING: For your own safety, use two or more people to perform the stability test or serious injury could result.

3.With one person in front of the stand, and the other person behind, lift the front of the stand slightly, remove the block of wood, and allow the stand to drop to the floor.

4.Perform this same test with the block of wood under the rear leg (HH).

5.If the stand tends to tip to the front, reposition the tool toward the rear of the stand. If the stand tends to tip to the rear, reposition the tool forward. Make your adjustment, then repeat the test.

8