Powermatic WP2510 operating instructions Fast Program 10 sets, Entering preset target values

Page 24

3. Fast Program (10 sets)

To facilitate frequently used positions, such as different board thicknesses, the keys 0 to 9 have associated preset target values. By pressing one of these keys, its target value is loaded automatically, and the positioning can be started immediately.

Entering preset target values:

Step 1: Press

Step 2: Select a key 0 to 9 (total of 10 values).

Step 3: Enter the target value.

Step 4: Press

to confirm.

Follow the same procedure for entering the other preset target values.

Press

to exit.

Example: Program 0 = 10.00mm; Program 1 = 20.00mm

Step 1: Press

Display

Step 2: Press

............................................. .[select program key 0]

Step 3: Press

............................................[enter value]

Step 4: Press

.................................................................[complete]

24

Image 24
Contents Inch Planer Warranty and Service Warranty PeriodTable of Contents Page Page Introduction WP-2510 floor diagram Specifications Tefc induction, 1/2HP, 3PH, 60HzContents of the Shipping Container UnpackingInstallation and Assembly Dust HoodGrounding Instructions Volt OperationAdjustments Converting from 230 Volt to 460 VoltTest Run Controller Set-UpFeed Rate Belt TensionOpening Hood Replacing or Rotating Knife InsertsPlaner’s Feed System Anti-Kickback FingersChipbreaker Pressure Bar Table Adjustments Test Cutting and Troubleshooting Feed RestrictionClip Marks Maintenance OperationLubrication Controller M15S Operating Instructions Front Panel OverviewManual Mode Operation ModesSetting Target Value Start/Stop/CancelExample Entering preset target values Fast Program 10 setsExecute Select Positioning Mode Select Counting directionSet Software Limit Hi/Lo End Set TolerancesSet Low Speed Limit To set low speed limitEnter Parameter Setttings Mode Set Linear CorrectionCheck Software Version Load Datum ValuesExample Set Device Resolution 13. IN/MM ConversionCalibration 16. M15S Troubleshooting Display 17. M15S Specifications 18. M15S Parameters Troubleshooting Planer Operating Problems Troubleshooting Mechanical and Electrical Problems Replacement Parts Column Assembly Parts List Column Assembly Index No. Part No Description Size QtyWP2510-458 Gearbox Assembly Parts List Gearbox Assembly Parts List Cutterhead Assembly WP2510-254 Table Assembly Parts List Table Assembly Base Assembly Parts List Base Assembly WP2510-660 120 WP2510-6120 Parts List Top Cover Assembly Parts List Electrical Box Assembly Electrical Connections 230Volt Electrical Connections 460Volt New Sanford Rd LaVergne, Tennessee
Related manuals
Manual 56 pages 10.84 Kb