Powermatic WP2510 operating instructions 13. IN/MM Conversion, Set Device Resolution, Calibration

Page 32

13. IN/MM Conversion

The dedicated mm/inch key allows for immediate switch of the units between millimeters and inches. The LEDs on the key indicate the selected unit. Switching between MM and INCHES has no effect on the control functions.

14. Set Device Resolution

Step 1: Press

Step 2: Use

to select resolution.

Step 3: Press

to confirm or press

to clear.

15. Calibration

Step 1: Press

Display

Step 2: Use

to move the planer table until

M15S terminates the calibration and restarts.

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Inch Planer Warranty and Service Warranty PeriodTable of Contents Page Page Introduction WP-2510 floor diagram Specifications Tefc induction, 1/2HP, 3PH, 60HzContents of the Shipping Container UnpackingInstallation and Assembly Dust HoodGrounding Instructions Volt OperationAdjustments Converting from 230 Volt to 460 VoltTest Run Controller Set-UpFeed Rate Belt TensionOpening Hood Replacing or Rotating Knife InsertsPlaner’s Feed System Anti-Kickback FingersChipbreaker Pressure Bar Table Adjustments Test Cutting and Troubleshooting Feed RestrictionClip Marks Lubrication MaintenanceOperation Controller M15S Operating Instructions Front Panel OverviewManual Mode Operation ModesSetting Target Value Start/Stop/CancelExample Entering preset target values Fast Program 10 setsExecute Select Positioning Mode Select Counting directionSet Software Limit Hi/Lo End Set TolerancesSet Low Speed Limit To set low speed limitEnter Parameter Setttings Mode Set Linear CorrectionCheck Software Version Load Datum ValuesExample Calibration Set Device Resolution13. IN/MM Conversion 16. M15S Troubleshooting Display 17. M15S Specifications 18. M15S Parameters Troubleshooting Planer Operating Problems Troubleshooting Mechanical and Electrical Problems Replacement Parts Column Assembly Parts List Column Assembly Index No. Part No Description Size QtyWP2510-458 Gearbox Assembly Parts List Gearbox Assembly Parts List Cutterhead Assembly WP2510-254 Table Assembly Parts List Table Assembly Base Assembly Parts List Base Assembly WP2510-660 120 WP2510-6120 Parts List Top Cover Assembly Parts List Electrical Box Assembly Electrical Connections 230Volt Electrical Connections 460Volt New Sanford Rd LaVergne, Tennessee
Related manuals
Manual 56 pages 10.84 Kb
Top Page Image Contents