Electrolux 22-785 instruction manual Troubleshooting Maintenance, Lubrication

Page 18

MACHINE USE

When using your machine, you may want to follow these few simple steps for achieving the best results possible.

1.True Up One Face – Feed one face of the board over a jointer, making thin cuts with each pass, until the entire surface is flat.

2.Plane to Thickness – Place the side you just surfaced in STEP 1 face down and feed the board through the planer, plane until this side is flat. Then plane both sides of the board until you are satisfied with the thickness, making thin cuts, alternating sides with each pass. If during the planing operation you notice the board twisting, warping or bowing, repeat STEP 1 and true up one face.

3.When planing long stock, provide table extensions to support the infeed and outfeed end of the workpiece.

4.For best results, always engage cutterhead lock before planing, plane with the grain only, and keep planer table clean. Occasionally, wax table surface to reduce friction during the planing operation.

5.Cross-cut to Final LengthCross-cut lumber to final length.

THE KNIVES ON THE PLANER WILL NOT WEAR EVENLY BY FEEDING THE WOOD THROUGH THE SAME SPOT ON THE TABLE EVERY TIME. FEED THE WOOD THROUGH THE PLANER AT DIFFERENT SPOTS ON THE TABLE WHEN POSSIBLE, TO HELP ELIMINATE UNEVEN WEAR OF THE KNIVES.

TROUBLESHOOTING

For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

MAINTENANCE

A

Fig. 53

D

E

C

Fig. 55

LUBRICATION

The gear box oil should be changed once a year. Use extreme pressure gear oil, available from Delta in one pint cans (you will need approximately 20 oz.). The gear box drain plug is shown at (A) Fig. 53. The oil fill and level plug is shown at (B) Fig. 54.

The four raising screws, two of which are shown at (C)

B

Fig. 54

F

Fig. 56

Fig. 55, should be lubricated as required using a common grease.

Periodically remove screw (D) Fig. 55, and side cover

(E). Thoroughly clean chains and sprockets (F) Fig. 56, and lubricate using a light machine oil. Replace side cover (E) Fig. 55, and secure with screw (D).

18

Image 18
Contents Planer Table of Contents Important Safety InstructionsSafety Guidelines Definitions California PropositionGeneral Safety Rules Important Safety InstructionsAdditional Specific Safety Rules Refer to them often and use them to instruct othersPower Connections Motor SpecificationsGrounding Instructions Carton Contents Functional DescriptionAssembly Tools Required AssemblyUnpacking and Cleaning Assembly Time EstimateCuttinghead Raising and Lowering Handwheel Lifting the MachineAssembling TOP Cover and Dust Chute Operating Controls and AdjustmentsLocking Switch in the OFF Position Starting and Stopping PlanerDepth of CUT Adjustment Feed Speed ControlAdjusting Belt Tension CHECKING, Adjusting and Replacing KnivesANTI-KICKBACK Fingers Page Adjusting Height Chipbreaker Constructing Gage BlockAdjusting Height Infeed Roller Adjusting Height Outfeed RollerAdjusting Spring Tension of Infeed and Outfeed Rollers Adjusting Table RollersAdjusting Cuttinghead Parallel to Table Troubleshooting Maintenance LubricationService AccessoriesWarranty Canadian PORTER-CABLE Delta Service Centers