Electrolux 22-785 Cuttinghead Raising and Lowering Handwheel, Lifting the Machine

Page 9

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

CUTTINGHEAD RAISING AND LOWERING HANDWHEEL

1.Insert key (A) Fig. 7, into keyway (B) of raising and lowering shaft.

2.Assemble handwheel (C) Fig. 8, to raising and lower- ing shaft as shown. Make sure key, which was assembled to shaft in STEP 1, is engaged with keyway in hub of handwheel (C).

3.Assemble decal (D) Fig. 8, to raising and lowering shaft as shown.

4.Fasten handwheel (C) Fig. 8, to raising and lowering shaft using an M10 flat washer (E) and an M10 hex nut

(F) supplied.

5.Assemble handle (G) Fig. 8, to handwheel (C) as shown.

6.Loosen two head locking knobs, one of which is shown at (G) Fig. 9, and turn handwheel assembly (H) clockwise to raise head assembly. Remove the protective shipping block (J).

LIFTING THE MACHINE

1.IMPORTANT: CARE MUST BE TAKEN WHEN LIFTING THE MACHINE ONTO A STAND OR WORKBENCH. THE PLANER IS VERY HEAVY AND A MINIMUM OF FOUR PEOPLE WILL BE REQUIRED TO LIFT THE MACHINE AS FOLLOWS:

2.Raise the cuttinghead (A) Fig. 10, by turning the raising and lowering handwheel (B) clockwise, and insert two 6 or 8 foot long 2 x 4’s (C) between the cuttinghead and table as shown. Lower the cuttinghead just until it touches the 2 x 4 ‘s (C) Fig. 10, so that they are positioned solidly between the table and cuttinghead. Then with two people on each end of the 2 x 4’s, move the machine to its desired location.

B

A

Fig. 7

G

D F

C

E

Fig. 8

H

JG

Fig. 9

B

A

C

Fig. 10

9

Image 9
Contents Planer Important Safety Instructions Table of ContentsCalifornia Proposition Safety Guidelines DefinitionsImportant Safety Instructions General Safety RulesRefer to them often and use them to instruct others Additional Specific Safety RulesPower Connections Motor SpecificationsGrounding Instructions Functional Description Carton ContentsUnpacking and Cleaning AssemblyAssembly Tools Required Assembly Time EstimateLifting the Machine Cuttinghead Raising and Lowering HandwheelLocking Switch in the OFF Position Operating Controls and AdjustmentsAssembling TOP Cover and Dust Chute Starting and Stopping PlanerFeed Speed Control Depth of CUT AdjustmentAdjusting Belt Tension CHECKING, Adjusting and Replacing KnivesANTI-KICKBACK Fingers Page Constructing Gage Block Adjusting Height ChipbreakerAdjusting Height Outfeed Roller Adjusting Height Infeed RollerAdjusting Table Rollers Adjusting Spring Tension of Infeed and Outfeed RollersAdjusting Cuttinghead Parallel to Table Lubrication Troubleshooting MaintenanceService AccessoriesWarranty Canadian PORTER-CABLE Delta Service Centers