SECTION 2: CIRCUIT REQUIREMENTS
110V Operation |
| 220V Operation |
|
|
|
|
|
|
The motor supplied with the G1037 is a dual volt- age motor, prewired for 110V. Under normal use, the motor draws approximately 17 amps @ 110V,
8.5@ 220V. We recommend using a 20 amp cir- cuit breaker or a 30 amp slow blow fuse for 110V or 220V operation. This should be satisfactory for normal use, while preventing motor damage from high heat caused by overload. If frequent circuit failures occur when using the planer/moulder, contact our service department or your local elec- trical contractor.
An instruction sheet has been included for rewiring for 220V. If this sheet is missing, call the appropriate service center for more information. Do not attempt to rewire without the instruction sheet.
Figure 1. Recommended 220V receptacle.
|
|
|
|
|
|
|
|
|
|
|
|
| G1037 Planer / Moulder | ||