Grizzly instruction manual Chip Deflector Feed Speed, Setup for 24 F.P.M G1037 Planer / Moulder

Page 18

Chip Deflector

Feed Speed

 

 

 

 

 

 

Before planing, adjust the chip guide plate so that there is a clearance of at least 18'' between the guide plate and the planer knife tips. Before moulding, it is very important to move the chip guide plate away from the moulding knives. Failure to do so will result in damage to the Planer/Moulder.

CAUTION: When moulding, be sure to move the chip guide plate away to prevent it from being hit by the moulding cutter knives.

The chip breaker can be moved by loosening the wing nuts on top of the breaker. For moulding operations, move the chip breaker to the far front (toward the infeed side) position. For planing operations, move the chip breaker to the far rear position. Be sure to tighten the wing nuts after moving the chip breaker.

Figure 18.

The Planer/Moulder has a two speed gearbox that feeds the workpiece at 12 feet per minute (FPM) for improved surface finishing when plan- ing and moulding and 24 FPM for faster planing.

CAUTION: Be sure to unplug the planer/moulder and turn it OFF before changing the gear.

To change the feed speed:

1.Remove the nut that secures the gearbox cover and remove the cover.

2.Loosen the cap screw that holds the gears onto their shafts.

3.Remove the gears.

4.Put the new gears on.

Figure 19. Setup for 24 F.P.M.

 

 

 

 

 

 

 

 

 

 

 

 

-16-

 

G1037 Planer / Moulder

Image 18
Contents Planer Moulder Page Table of Contents Safety Safety Instructions For Power ToolsAdditional Safety Instructions For Planer-Moulders Circuit Requirements 110V Operation 220V OperationGrounding General Information Unpacking Piece Inventory Clean up Site Considerations Assembly Stand AssemblyMounting To Stand Mounting to standAdjustments Knife RemovalKnife Setting Bedboard Moulding Knives Chip Chute Setup for 24 F.P.M G1037 Planer / Moulder Chip Deflector Feed SpeedStock Pre-sizing Adjusting Scale Belt Tension Operations Test Run Thickness PlaningPlaning For Finish Maintenance GeneralLubricationClosure Machine Data G1037 Planer / Moulder Gear BOX G1037 Planer / Moulder Base Mechanism G1037 Planer / Moulder Upper Frame Upper PLATE, R & L Troubleshooting Troubleshooting Warranty and Returns