TROUBLESHOOTING
WARNING: For your own safety, turn the switch off and disconnect power source before troubleshooting.
Problem | Probable Cause | Remedy | ||
Poor feeding of lumber | 1. Inadequate feed roller pressure | 1. | Adjust feed roller tension | |
| 2. | Motor belt slipping | 2. | Tighten or replace motor |
|
|
|
| belts |
| 3. | Planer bed rough or dirty | 3. | Clean off pitch and |
|
|
|
| residue and wax planer |
|
|
|
| bed |
| 4. | 4. | Tighten | |
| 5. | Surface of feed roller too smooth | 5. | Lightly roughen the feed |
|
|
|
| roller surface with a piece |
|
|
|
| of sandpaper |
Table difficult to adjust | 1. Corner screw too tight | 1. | Adjust corner screw | |
| 2. | Corner screws not moving | 2. | Lubricate corner screw |
Board thickness doesn’t |
| Depth of cut scale incorrect |
| Adjust depth of cut scale |
match depth of cut scale |
|
|
|
|
Chain jumping | 1. Inadequate tension | 1. | Adjust chain tension | |
| 2. | Sprockets misaligned | 2. | Align sprockets |
| 3. | Sprockets worn | 3. | Replace sprockets & |
|
|
|
| chains |
Mechanical / Electrical | 1. Not plugged in | 1. | Check power source | |
Machine won’t start / restart | 2. Circuit breaker/fuse | 2. | Check power source | |
| 3. | Motor failure | 3. | Have motor checked |
| 4. | Loose wire | 4. | Have motor checked by |
|
|
|
| qualified electrician |
| 5. | Overload auto reset has not reset | 5. | Allow machine to cool |
|
|
|
| down and restart |
| 6. | Motor starter failure | 6. | Have motor starter |
|
|
|
| checked by qualified |
|
|
|
| electrician |
Repeated circuit tripping |
| 1. Too Heavy a cut | 1. | Take lighter cuts |
resulting in motor stoppage |
| 2. Circuit overloaded by multiple | 2. | Divert power usage to |
|
| machines or lights |
| other breakers |
G1037 Planer / Moulder |