The table rollers are factory set for average planing and are parallel to the table surface. If you desire to adjust the table rollers higher or lower, proceed as follows:
1.Disconnect machine from power source.
2.Lay a straight edge (B, Fig. 14) across both rollers.
3.On one side of the table, loosen the screws (C, Fig. 14) with a hex wrench, and turn the eccentric shafts (D, Fig. 14) to raise or lower the rollers.
4.When the proper height is achieved, tighten screws (C, Fig. 14).
5.Adjust the rollers from the opposite side of the table in the same manner.
Important: Be sure that the height of front and rear rollers are the same. The table rollers must always be set parallel to the table.
Adjusting Table Extension Rollers
1.Place a straight edge over the extension roller and the table, as shown in Fig. 15, to make sure the extension roller and table are at the same height. If necessary, adjust the table extension rollers as follows:
2.Loosen the screws and washers (A, Fig. 15) to move the extension roller to the proper position, then retighten the screws.
3.Adjust both front and rear extension rollers in the same manner.
Figure 13
Figure 14
Figure 15
11