Handwheel
1.Remove the nut and washer from the gearbox shaft, and place the handwheel onto the shaft (Fig. 5), making sure it is oriented so the handwheel slips over the key.
2.Place flat washer and hex nut on shaft and tighten with wrench.
3.Mount the handle in the threaded hole in the handwheel, and tighten with a wrench placed over the flat on the handle.
Figure 5
Table Extension Rollers
Mount the table extension rollers to the table using the provided hex cap screws and washers (A, Fig. 6). The rollers should be adjusted before operating the planer; see Adjusting Table Extension Rollers on page 11.
Figure 6
Dust Collection Hood
The dust collection hood (Fig. 6a) comes standard with the model
Figure 6a
8