FUNCTIONALDESCRIPTION
Installingor removingbattery cartridge
*Always switch off the tool before inser- tion or removal of the battery cartridge.
*To remove the battery cartridge, withdraw it from the tool while pressingthe buttons on both sides of the cartridge.
*To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, caus- ing injury to you or someone around you.
*Do not use force when inserting the battely cartridge. If the cartridge does not slide in easily, it is not being inserted correctly.
Charging
*Your new battery cartridge is not charged. You will need to charge it before use. Use the high capacity battery charger Model DC1411 to charge the battery cartridge.
*Plug the high capacity battery charger into the proper A.C. voltage source. The charg- ing light will flash in green color.
*Insert the battely cartridge so that the plus and minus terminals on the battely cartridge are on the same sides as their respective markings on the high capacity battery charger. Insert the cartridge fully
into the port so that it rests on the charger p'Cirt floor.
*When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging light will remain lit steadily during charging.
*When the charging light color changes from red to green, the charging cycle is complete.
*If you leave the battery cartridge in the charger after the charging cycle is complete, the
charger will switch into its "trickle charge (maintenance charge)" mode which will last approximately 24 hours.
*After charging, unplug the charger from the power source.
9